1
Verifying Your TV, VCR and AUX Mode Codes
You can verify the accepted programming codes for each mode by following these steps.
1.Press the TV, VCR, AUX key for at least three seconds or until the LED blinks.
2.Press the "INFO" key.
3.The LED will blink, indicating the code of your TV, VCR or auxiliary component in the following sequence. For example, if your TV code is for a Tandy brand TV (code 105) the blink pattern will be:
-Pause>long blink "1;"
-Pause>short blink "0;"
-Pause>long blink, long blink, long blink, long blink, long blink "5." A zero in the code will always be represented by a short blink.
4.For the AUX mode only, after the code is verified the appropriate mode key will blink to indicate the component being controlled.
If You Have More Than One Satellite Receiver
If you have more than one satellite receiver, you may want to prevent the remote controls from affecting the other receivers. To prevent this kind of interference, you must "pair" each remote control with one receiver. In order to do this, you will have to assign a new "address" to each pair of remote controls and receivers so that each pair functions independently of the others. If you have two or more receivers, see Chapter 10 for information about the procedure for changing addresses.
6