Motorola DCH6200 operation manual N T I L a T E

Page 4

 

V E N T I L A T E

 

 

2 inch space

 

2

 

2

inch

DCH6200

inch

During Installation

Do not place the cable terminal in an enclosed area where the cooling vents are blocked or impede the flow of air through the ventilation openings.

Install the terminal so that its position does not interfere with its proper ventilation. For example, do not place the terminal on a bed, sofa, rug, or similar surface that could block the ventilation openings.

Install the terminal away from heat sources such as radiators, heat registers and stoves. Installation of the terminal near consumer electronics devices, such as stereo receiver/amplifiers and televisions, is permitted as long as the air surrounding the terminal does not exceed 40º C (104º F).

Place the terminal on a flat surface not prone to vibration or impact.

Do not install the terminal in an area where condensation occurs.

To prevent the temporary loss of guide data and cause a temporarily non-responding terminal, do not plug the AC power cord into a switched power outlet.

FCC COMPLIANCE

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by Motorola for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

ii

Image 4
Contents DCH6200 Page Important Safety Instructions N T I L a T E FCC Declaration of Conformity Software License You mayGovernment Restricted Rights Page Contents Viii Introduction Front Panel Rear Panel Page Turning Power On and Off Adjusting the VolumeOperation Changing ChannelsCard OperationConnections Video Audio Optimizing Your DCH Receiver for HIGH-DEFINITION TV User Settings Setting DescriptionPixels Page ON-SCREEN Graphics Page Connecting Your DCH Receiver Video Connection Options Hdmi or IEEE-1394 Hdtv and SdtvConnecting Your DCH Receiver to an Hdtv Video Only DCH6200Connecting Hdtv Video CableConnecting Your DCH Receiver Connecting Your DCH Receiver Hdmi Connecting Your DCH Receiver Connecting Your DCH Receiver to a Stereo TV Sdtv Connecting a Stereo TV SdtvConnecting Your DCH Receiver VCR Connecting an A/V Receiver, TV, and VCR Recording Your Connections Data Features Data DevicesTroubleshooting Problem Possible SolutionTroubleshooting Troubleshooting Page