Rear Panel Analog Details

Analog Single-Ended RCA Output – This is the primary single ended RCA analog output. For optimum performance, use this output as the DAC is fundamentally single-ended.

Analog Balanced XLR Output – This is the balanced XLR analog output. This is an alternate output format.

Analog Single-Ended RCA Input – This is the single-ended analog input. This input is passed to the output with no change unless a volume option is installed. When the volume control is installed, this input is also. With advanced control options, this input can be either volume controlled or not, depending on the menu settings. This input is ideal for adding a vinyl input to your system. Minimum input impedance is 2 kohms. At 0 dB volume setting, the analog inputs are a direct pass-through. This input should be terminated when not in use.

REAR PANEL POWER INPUT

Power Input – This product must be plugged into a Platinum power base with both analog and digital supplies. It will work with both the Analog DAC desktop supply, Analog DAC power base or any of the DAC IV power bases.

REAR PANEL CONTROL MODULE

Control Interface – This optional interface allows the DAC to be controlled using a web based system This module would need to connect to a computer network.

RS-232– The RS-232 optional interface is used for controlling the DAC with a system controller.

REARPANELDIGITALINPUTS - (THREE MODULE MAX)

TheAnalog DAC can accommodate up to three input modules at one time, but they can be easily swapped in and out as your system changes. The order of the modules determines the priority of input selection in the auto select mode. The highest priority input will always interrupt the lower priority. So if you have a source that is always on, it should be set as the lowest priority so any other source can interrupt it. The highest priority input is closest to the analog outputs.

Each module is described below.