Memorex E-IDE software manual FCC Information U.S.A

Page 2

FCC INFORMATION (U.S.A.)

1.￿IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Memorex may void your authority, granted by the FCC, to use the product.

2.￿IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used (except: if cables are used on CSEL System, they won’t work). Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.

3.￿NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class ￿B￿ digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the product ￿OFF￿ and ￿ON￿, please try to eliminate the problem by using one of the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change ￿ the lead-in to coaxial type cable.

If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Memorex Products, Inc. 17777 Center Court Dr. #800, Cerritos, CA 90703.

Image 2
Contents 16x FCC Information U.S.A Table of Contents About your new Memorex DVD Recorder IntroductionCongratulations About Double-Layer RecordingSetup Flowchart Tools Required for installationHardware Installation About the E-IDE Atapi InterfaceSlave Change the jumper to the Slave position if Physical Installation of Your NEW DVD RecorderMaster Leave the jumper switch on the Master position if Cable.10Analog Connection Not IncludedSome pressure to completely secure them in place Reconnect the computer to the AC outlet and power it upIf so, you may skip to . If not, please proceed to step Process describedLoading a Disc Operating Your NEW DriveFront Panel Ejecting a DiscIncluded Software Creating CDS and Dvds Nero StartSmart bar Using Nero StartSmart-the Command CenterUser Interface and Navigation 6.4.1 Standard view Clicking on this button closes Nero StartSmartStandard mode Expert mode Standard modeExpert mode Navigation in Nero StartSmartBurning DISCS-THE Basics Assigning programsNero ProductCenter Make a Data DiscWriting Speed Current RecorderDisc name Number of copiesMake an Audio Disc Click on the Next button to advance to the selection window Make a Video Disc Write to Hard Volume NameBurn to Disc FolderCopy a Disc Upgrade Options Updates free downloads FAQ Software Related Drive is not recognized TroubleshootingDisc tray does not open when you press the eject button Drive is not recognized by the operating systemPlayback of an audio CD CD-DA is inaudible Drive does not power upNo data can be read from a disc Drive does not operate correctlyAppendix About the FirmwareSafety Precautions About CD/DVD discs Copyright 2004 Memorex Products, Inc. Cerritos, CA 5395