Memorex DVR H264 user manual Pantilt Setup, Spot Monitor Setup, Switching Interval, Alarm POP-UP

Network (JPEG2000+H.264)

Network Stand Alone DVR

2)RS-232C SETUP

User can control the DVR via RS-232C port. Connect DVR to PC via RS-232C port and control DVR using keyboard of PC.

This function is mainly for programmer who wants to control DVR as part of many devices connected to PC system, as in SI project.

CHAP. 5 Set Up

	RS-232C SETUP
SPEED	115200
LENGTH	8
STOP BIT	1
PARITY	NONE

SELECT : ▲▼, CHANGE VALUE : + -

3) PANTILT SETUP

It is to set parameters for PTZ camera connected to DVR unit. DVR unit already includes all protocols of well-known PTZ cameras like PELCO D type PTZ camera, and user just select MODEL and set other parameters to control this PTZ cameras, using operation buttons on the front panel of DVR.

PANTILT SETUP			COMMAND SETTING
		CHANNEL		01
		MODEL		PELCO-D
		PTZ ID		000
COMMAND SETTING	￿ PTZ camera set	BAUDRATE		2400 BPS
		CMD DELAY		1 MSEC
SPEED SETTING	￿ PTZ speed set
		COMMAND		PAN/TILT STOP
		LENGTH		07
		CODE		FF	00	00	00
				00	00	00	00
SELECT : ▲▼, & [ENTER]		SELECT : ▲▼, CHANGE VALUE : + -

(1)CHANNEL : Select channel

(2)MODEL : Select camera model (protocol type) per each channel

(3)PTZ ID : Select ID

(4)BAUDRATE : Select data transmission speed

(5)CMD DELAY : Select command delay time

4)SPOT MONITOR SETUP

SPOT MONITOR SETUP			(1) SWITCHING INTERVAL
			Channel switching time (01 sec. ~ 99 sec.)
SWITCH INTERVAL
			(2) ALARM POP-UP
03 SEC
ALARM POP UP			When ALARM is detected, the image of channel
ON			connected with Alarm sensor pops up.
MOTION POP UP
			Set ALARM detection pop-up (ON/OFF)
ON
EVENT POP UP DURATION		01
SEC			(3) MOTION POP-UP
			Set MOTION detection pop-up (ON/OFF)
SELECT: ▲▼, CHANGE	VALUE : + -

36