True Fitness 500U, 600R, 500R, 600U manual No Resistance 750U, 750R, Enter DA resistance test mode

Symptom Probable Cause Corrective Action Recommended Tools

NO RESISTANCE 750U, 750R

Console Set

Defective Cables

Power Resistance

Brake Harness/

Lower Board

•Remove console bolts to access 7-pin connector. Do not disconnect console set.

•Enter DA (resistance) test mode. (Page 2).

•Press + key to force .7 VDC out of panel.

•Set meter for DC Volts. Measure between #2 pin and #4 pin at 7- pin connector.

•Is .7 VDC present? No- replace console set. If present, continue on.

--------

•Remove right mast cover and handlebar.

•Measure between the #2and #4 wires at the 7 –pin connector on the lower board.

•Is .7 VDC present? No- replace cable for console. If present, continue on.

--------

•DO NOT PEDAL.

•Set meter for resistance. Disconnect 3- pin connector at the lower control board. Measure resistance between #1 pin and #3 pin.

•Resistance should be 10 ohms, +/- 1 ohm.

•If less than 10 Ohms- replace power resistance. If resistance checks OK, continue on.

--------

•DO NOT PEDAL.

•Remove main body cover, set meter for continuity.

•Disconnect brake cable from brake and lower board.

•Check continuity of all wires in cable.

•Check for cross continuity- this would indicate multiple shorts in the cable.

•No continuity? Replace Brake cable.

•Yes continuity? Replace lower board.

Note:

You must pedal at least 30 RPM when performing any voltage test. You may require the assistance of another person when performing voltage checks.

Multi-meter

Page 12

Support Services 800-883-8783 Mon-Fri 8:30am-5:00pm Central Time Zone Fax: 636-272-7148