Marshall electronic V-R261-IMD-HDSDI manual LED Tally, Time Code, Audio Monitor

Page 21

On-Screen Menu (continued)

OSD CONFIGURATION SUBMENU (continued)

LED Tally

Use this setting to enable or disable the LED Tally. When enabled, the yellow, red and green LEDs above the display will respond to tally commands, according to the Tally Source setting (see page 23).

Time Code

Use this setting to enable time code display on the screen. Time code is de-embedded from the vertical ancillary data (VANC) within the SDI signal. Two types of time code can be selected to display on the screen: LTC (linear time code) or VITC (vertical interval time code).

The position of the time code display varies based on the aspect ratio setting and presence of IMD text (see Aspect

Ratio diagrams on page 13).

Hours Minutes Seconds Frames

00:00:00:00

Time Code display

Audio Monitor

Use the Audio Monitor menu option to enable or disable the audio presence indicator icon. When enabled, this icon indicates whether embedded audio is present in the SDI video input. A red circle and cross will flash on the icon if no embedded audio is present.

Embedded Audio Present

No Embedded Audio

21

Image 21
Contents Operating Instructions Contents Product Overview FeaturesInstallation Installation and Initial SetupConnections, Power-On and Initial Setup UnpackingPower Button Top and Front Panel FeaturesRS-422/485 Serial Interface Rear Panel FeaturesCompatible Input Formats On-Screen MenuStructure Overview Main Menu and Navigation On-Screen MenuMarkers Marker Setup SubmenuMarker Setup Submenu Marker BackgroundCenter Marker Video Configuration Submenu Monochrome ModeBlue-Only Mode Video Configuration Submenu Pixel-to-Pixel ModeAspect Ratio Settings Curtain Color Ctemp/Gamma Color Configuration SubmenuRed, Green, and Blue Offset Red, Green, and Blue GainSystem Configuration Submenu Gray LevelsUser-Definable Function Buttons Saving and Loading User Presets System Configuration SubmenuSave Defaults Software Version DisplayDeinterlacer Submenu Deinterlacer Mode Film Indicator Film Mode Deinterlacer Submenu Motion DisplayOSD Configuration Submenu IMD StateStatus Display OSD Tally OSD Configuration SubmenuLED Tally Time CodeAudio Monitor IMD Configuration Submenu OverviewIMD Protocol IMD Configuration Submenu Tally Source IMD Tally ModeCRC Service SubmenuPanel SpecificationsWarranty MaintenanceScreen Cleaning Faceplate DustingMarshall Electronics, Inc