Marshall electronic V-R261-IMD-HDSDI manual Tally Source, IMD Tally Mode

Page 24

On-Screen Menu (continued)

IMD CONFIGURATION SUBMENU (continued)

Tally Source

The V-R261-IMD-HDSDI tally (OSD and LED) can be controlled in a variety of different ways. Use the Tally Source setting to choose how tally is controlled:

Standard

Use the Standard setting to control tally via contact closure on the HD-15 tally interface.

Image Video HW

Use the Image Video HW setting to control Image Video tally states via contact closure on the HD-15 tally interface. Contact closure of the Red pin corresponds to Image Video Tally 1, and the Green pin maps to Image Video Tally 2. Contact closure (ground) corresponds to a LOW state, and open circuit corresponds to a HIGH state. This mode requires the IMD Tally Mode parameter to be set. Consult Image Video documentation for further information.

Image Video 422

Use the Image Video 422 setting to control Image Video tally states via the Image Video serial protocol. LED and OSD tally will be disabled in this mode, as Image Video tally states are manifested in the text color and other parameters. This mode requires the IMD Tally Mode parameter to be set. Consult Image Video documentation for further information.

Standard + IV422

Use the Image Video 422 setting to control Image Video tally states via the Image Video serial protocol, while controlling LED and OSD tally using contact closure on the HD-15 tally interface. This mode requires the IMD Tally Mode parameter to be set. Consult Image Video documentation for further information.

TSL/MEI 422

Use the TSL/MEI 422 setting to control OSD and LED tally via the TSL or Marshall serial protocols.

IMD Tally Mode

Use this setting when using Image Video tally control. Choose one of the following settings, in conjunction with the Image Video controlling device. T1, T2, T1T2, T2T1, T1-,T2-,T1T2-,T2T1-. Consult Image Video documentation for further information.

24

Image 24
Contents Operating Instructions Contents Features Product OverviewInstallation and Initial Setup InstallationConnections, Power-On and Initial Setup UnpackingTop and Front Panel Features Power ButtonRear Panel Features RS-422/485 Serial InterfaceCompatible Input Formats On-Screen MenuStructure Overview On-Screen Menu Main Menu and NavigationMarker Setup Submenu MarkersMarker Setup Submenu Marker BackgroundCenter Marker Video Configuration Submenu Monochrome ModeBlue-Only Mode Video Configuration Submenu Pixel-to-Pixel ModeAspect Ratio Settings Curtain Color Color Configuration Submenu Ctemp/GammaRed, Green, and Blue Offset Red, Green, and Blue GainSystem Configuration Submenu Gray LevelsUser-Definable Function Buttons System Configuration Submenu Saving and Loading User PresetsSave Defaults Software Version DisplayDeinterlacer Mode Deinterlacer SubmenuFilm Mode Film IndicatorDeinterlacer Submenu Motion DisplayOSD Configuration Submenu IMD StateStatus Display OSD Configuration Submenu OSD TallyLED Tally Time CodeAudio Monitor IMD Configuration Submenu OverviewIMD Protocol IMD Configuration Submenu IMD Tally Mode Tally SourceService Submenu CRCSpecifications PanelMaintenance WarrantyScreen Cleaning Faceplate DustingMarshall Electronics, Inc