Marantz DV6400 manual Risk of Electric Shock Do not Open, Operating Environment, Laser Safety

Page 2

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

 

 

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Operating Environment

Operating environment temperature and humidity:

+5 C to +35 C (+41 F to +95 F); less than 85%RH (cooling vents not blocked) Do not install in the following locations

Location exposed to direct sunlight or strong artificial light

Location exposed to high humidity, or poorly ventilated location

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

NOTE:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CAUTION:

This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment.

To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections.

LASER SAFETY

This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AVOID EXPOSURE TO BEAM (WARNING LOCATION: INSIDE ON LASER COVERSHIELD)

Information to User

Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.

This product is for general household purposes. Any failure due to use for other than household purposes (such as long

-term use for business purposes in a restaurant or use in a car or ship) and whichrequires repair will be changed for even during the warranty period.

Do not remove the cover from the equipment.

Do not insert anything into the equipment through the ventilation holes.

Do not handle the mains lead with wet hands.

Make a space of about 0.1 meter around the unit.

IMPORANT NOTICE [For U.S. model]

The serial number for this equipment is located on the rear panel. Please write this serial number on your enclosed warranty card and keep it in a secure area. This is for your security.

– 2 –

EN

Image 2
Contents Model DV6400 User Guide ViiOperating Environment Laser SafetyRisk of Electric Shock Do not Open Important Safety Instructions Read Before Operating EquipmentTable of Contents Introduction Supplied AccessoriesSymbols Used in this Manual About CopyrightDisc Types About the DiscsPlayable Discs ¡CD-ROM ¡VSDFeatures Functional Overview Remote ControlFront Panel Tour of the remote control DVD VCD PowerDVD VCD Displays During Operation Using the remote controlDisplay Loading the BatteriesDigital OUT Jacks Hook UPSDescription rear panel Video OUT JackStereo system Audio Audio Input Jacks DVD Analog Audio Out MethodConnection to an audio system 1ch Audio OUT Connection to 5.1-channel Surround Sound systemTo 5.1ch Audio in Jacks Best picture HOW to Connect to a TV Without AUDIO/VIDEO Input JacksBasic Audio Connection to a TV for video MethodDVD-V DVD-A DVD-V VCD CDVCD DVD-A DVD-VMP3 WMA DVD-A DVD-V VCDDVD-A DVD-V CD DVD-V VCDMP3 WMA DVD-A CDDVD-A Program DVD-A MP3 Jpeg WMARepeat Information on MP3, Jpeg and WMA discs MP3 Jpeg WMARandom Playback For discs on which MP3, Jpeg or WMA tracks are recordedOn-Screen Information Slide Show ModeJpeg Track SelectionCD VCD Random Playback Audio Language or Sound ModeStereo Sound Mode Camera Angle Subtitle LanguageChanging the On-Screen Display CD MP3 WMA Black Level SettingMarker Setup Screen Virtual SurroundDisplay Setting DVD SetupLanguage Setting QuickSpeaker Size Audio SettingDelay Time Parental Level If YOU Forget the PasswordParental Control BalanceLanguage Code CodeCleaning Discs MaintenanceCleaning the Cabinet Cleaning the disc lensTroubleshooting Guide Problem SolutionSpecifications Memo Memo Europe JapanMarantz Japan, Inc