OPERATING THE PLASMA DISPLAY
BASIC OPERATIONS
POWER
VOL
POWER
MUTE
SCREEN MODE
STILL
INPUT SELECT
INPUT SELECT
DISPLAY
The following is a simple explanation of the pro- cedure for turning the power of the display ON or in STANDBY, and the procedure for selecting the input signal.
The procedure described here is for the remote control, however the POWER, INPUT SELECT and VOLUME buttons on the plasma display can also be used in the same way.
1 Press the POWER button.
Confirm that the STANDBY indicator is lit before pressing the POWER button.
The power turns ON and the ON indicator on the main unit lights up. The STANDBY indica- tor on the main unit disappears.
NOTE:
•It takes approximately 8 seconds for the screen to display after turning the power ON, but this is not a malfunction.
2 Select the input signal by pressing the INPUT SELECT button.
Each time you switch the input, the name of the selected input terminal is displayed on the screen for approximately 4 seconds.
NOTE:
•"No signal" is displayed on the screen if there is no input from the selected terminal and there is no message currently displayed on the screen for volume adjustment or the setup menu, etc.
•If there is no video signal and there has been no operation from the remote control or the buttons on the main unit for more than 15 minutes, the auto
3 Adjust the volume and screen size according to your requirements.
Perform adjustments to the volume (VOL K / L button), screen aspect ratio (SCREEN MODE button), and picture settings (MENU button)
NOTE:
•When you adjust the volume with the VOL K / L button, a message such as the following is dis- played on the screen. This message disappears approximately 4 seconds after performing adjust- ments.
•If you turn the audio mute on, a message slowly flashes on the screen. At this time, if you press another button, this flashing stops.
•To turn the audio mute off, either press the MUTE button again or press the VOL K / L button.
•If you press either the PREVIOUS, K, L, B or { button in a mode apart from the image adjustment mode. A message such as the following is dis- played.
4 Press the POWER button to turn the power
STANDBY.
The ON indicator on the main unit disappears and the STANDBY indicator lights up.
NOTE:
•You cannot turn the power ON for approximately 3 seconds after the power enters the standby mode. Do not turn the power STANDBY and then ON again in a short time interval.
•Even if the power is turned STANDBY, the main unit is in the standby mode. In order to shut the main power of the display OFF, it is necessary to remove the AC cord from the power outlet.
8