CHANNEL SETTINGS
AUTOSCAN
If you switch wires (e.g. between antenna and CATV) or if you move the TV to a different area after the initial setting, you need to perform Autoscan again. This function lets you easily select the receivable channels with [CH K/L] and the TV memorizes them even if you switch wires.
|
| STILL |
- | 0 |
|
SETUP |
| SCREEN |
| MODE | |
| ENTER |
|
BACK |
| INFO |
| CH RETURN |
|
VOL. | MUTE | CH |
|
|
NOTE:
•Make sure the TV is connected to antenna or cable.
1Display the setup screen.
•Press [SETUP].
The following setup screen is displayed.
3For TV channels, using [K/L], select “Air”. For CATV channels, select “Cable”.
Autoscan |
|
|
Autoscan will rescan all channels. | Back | |
| ||
This may take a while to complete. | Air | |
|
| |
Select the destination of "ANT IN" jack. | Cable | |
|
| |
Air |
| Cable |
| 1hour | |
|
| |
Cable | Or |
|
| ANT IN |
|
•Press [ENTER].
Scanning and memorizing the channels auto- matically starts.
Now the system is scanning for channels, please wait.
72%
| Analog channels |
| 10ch |
|
|
|
|
|
|
|
|
|
|
|
| ||
| Digital channels |
| 6ch |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| SETUP | Exit | |||
|
| ||||
|
|
|
|
|
|
•When the scanning and memorizing are com- pleted, the lowest memorized channel in the broadcasting will be displayed.
NOTES:
•If you connect a cable system directly, contact the CATV installer.
•If you press [POWER] or [SETUP] during Autoscan, this setting will be canceled.
•If there is no reception connected or poor signal is detected, a Hint will appear on screen once scanning stops.
INITIAL SETTINGS / CHANNEL SETTINGS
2Select “CHANNEL” and press [ENTER] to con- firm.
• Using [K/L], select “Autoscan”.
Channell
Autoscan
Channel List
Manual Register
Antenna
•Press [ENTER].
13
EN