FUNAI TB100HH9 owner manual Precautions, Important Copyright Information

Page 4

Before Using

Precautions

Location

For safe operation and satisfactory performance of this product, keep the following in mind when selecting a place for its installation:

•Shield it from direct sunlight and keep it away from sources of intense heat.

•Avoid dusty or humid places.

•Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the product. Do not place the product on a carpet because this will block the ventilation holes.

•Install the product in a horizontal position.

•Avoid locations subject to strong vibration.

•Do not place this product near strong magnetic fields.

Important Copyright Information

Unauthorized recording or use of broadcast television programming, video tape, film or other copyrighted material may violate applicable copyright laws. We assume no responsibility for the unauthorized duplication, use or other acts which infringe upon the rights of copyright owners.

FCC WARNING - This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

•Avoid moving this product to locations where temperature differences are extreme.

Avoid the Hazards of Electrical Shock and Fire

•

•

Do not handle the power cord with wet hands. Do not pull on the power cord when disconnecting it from an AC wall outlet. Grasp it by the plug.

•If by accident, water is spilled on your the product, unplug the power cord immediately and take the product to our Authorized Service Center for servicing.

•Do not place anything directly on top of the product.

A Note about Recycling

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

4

EN

Image 4

Contents TB100HH9 Before Using Risk of Electric Shock Do not OpenInsert Precautions Important Copyright InformationBefore Using Advanced Operation B l e o f C o n t e n t sOverview Installing Batteries AccessoriesInformation on Digital Broadcasting Remote Control Location of ControlsRemote control sensor Power indicator Front PanelRear Panel Video OUT jack yellowConnecting to a TV without A/V Jacks Connecting to a TV with A/V JacksConnections White red YellowConnecting to a Cable Box Optional WhiteRed EllowConnecting to Other Devices Red yellowInitial Setup Setup Wizard Initial SetupPress STANDBY-ON on the remote control to activate the STB Appropriate Viewing ChannelSelect Continue using s / B, then press OK Select the language using K / L, then press OKSelect your time zone using K / L, then press OK Select Autoscan using K / L, then press OKBasic Operation Selecting Channels on the STBAbout Sub-channel Broadcasting Enter the main channel numberTo cancel still mode Press Audio repeatedlyPress Still Choosing Audio LanguageSelect the desired program using s / B Press DisplayPress EPG while watching TV Channel BannerPress Setup Select ADD/ Delete using K / L, then press OKAdvanced Operation Autoscan Receiving ChannelsPress Setup to exit Select Delete using K / L, then press OKPress OK again to add the channel to the channel map AddAdjusting Antenna Selecting Display ModePress Setup Select Detail using K / L, then press OK SelectDISPLAY MODEusing K / L, then press OKInformation on Display Mode Setting the Time Zone and D.S.T Daylight Saving TimePress Setup Select Time using K / L , then press OK Select Time Zone using K / L , then press OKSelect D.S.T using K / L , then press OK Select on or OFF using s / B , then press OKEnter the password using the Number buttons Chip OptionsSelect the desired rating type using K / L , then press OK Select the desired rating usingThen press OK repeatedly to switch between view and block Mpaa RatingSelect NEW Password using K / L , then press OK Enter the new 4-digit password using the Number buttonsPress Setup Select Detail using K / L , then press OK Select Manual using K / L , then press OKSelect Closed Caption using K / L , then press OK Closed Caption OptionsAuto Power Down Select desired amount of time using K / L , then press OKViewing Analog TV Method 1 MétodoSelect CH3 in RF OUT menu Select ch3 on your TVMethod 2 Método Select RF Through in RF OUTSelect the desired channel on your TV Press STANDBY-ON to activate the STBSetting RF OUT Using Setup to Switch RF OUT SettingSelect RF OUT using K / L, then press OK Select the desired setting using K / L, then press OKTroubleshooting OthersSpecifications Limited Warranty Customer Service Tel