RCA MR29410 manual Memorizing the Channels, Selecting the Video Signal-source

Page 19

1577575A.04 11/15/01 10:32 AM Page 4

O P E R AT I O N

Memorizing the Channels

Your TV can memorize and store all of the available channels for both “off-air” (anten- na) and cable channels. After the available channels are memorized, use the CHAN ▲ and CHAN ▼ buttons to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual).

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV (i.e., an antenna or a cable system).

1

Press MENU•PROG to

display the menu.

2

Press

two times to

select “Channel.”

3

Press .

The first line of the Channel menu is highlighted.

4

Repeatedly press

to

cycle through the

 

following choices:

 

ANT (antenna)

 

STD, HRC or IRC (all cable TV)

Note: STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area.

At this point the signal source has been selected. Proceed to “Storing

Channels in Memory” (next page).

4.4 CHAPTER FOUR: TV OPERATION

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Changing entertainment. Again Television User’s GuidePower Consumption 100-240V~50/60 Hz Important Safety Information Example Antenna Grounding Using the Remote InstallationYour New TV Operation Special FeaturesOther Information Familiarizing Yourself with the TV List of FeaturesAudio Inputs 1 Side Panel JacksRear Panel Jacks Video Inputs 1Antennas with 300-ohm Flat Twin Leads Connecting VHF and UHF AntennasSeparate VHF and UHF Antennas Connecting Cable TVConnecting to a Cable Box that Descrambles All Channels Antennas with 75-ohm Round LeadsANT IN, VHF IN, or simply, Connecting to a Cable Box that Descrambles Some ChannelsUnplug the cable or antenna from the back of the TV Connecting a VCRConnecting a Second VCR to Record from the TV Connecting a CamcorderInstalling Batteries in the Remote Control I N G T H E R E M O T E Remote Control ButtonsTurning the TV On and Off Plug & Play FeatureViewing the Menus Viewing the Menus and On-Screen DisplaysViewing the Display Selecting a Menu LanguageMemorizing the Channels Selecting the Video Signal-sourceStoring Channels in Memory Automatic Method Adding and Erasing Channels Manual Method Labeling the Channels Fine Tuning Channels Problem Possible Solution TroubleshootingUsing Your TV in Another Country Cleaning and Maintaining Your TVSpecifications 1577575A.06 11/15/01 1039 AM 1577575A.06 11/15/01 1039 AM
Top Page Image Contents