Pioneer S-DV9, XV-DV9 manual Disc / content format playback compatibility, Using the remote control

Page 9

Before you start

01

Putting the batteries in the remote control

•Open the battery compartment cover and insert the batteries as shown.

Use two AA/R6P batteries and follow the

indications ( , ) inside the compartment. Close the cover when you’re finished.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the system unit’s remote sensor.

•Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this system.

•Replace the batteries when you notice a fall off in the operating range of the remote.

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Don’t mix new and old batteries together.

•Don’t use different kinds of battery together—although they may look similar, different batteries may have different volt- ages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that isn’t going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

H048 En

Using the remote control

Keep in mind the following when using the remote control:

•Make sure that there are no obstacles between the remote and the remote sensor on the system unit.

•The remote has a range of about 7 m at an angle of less than 30º.

Disc / content format playback compatibility

This player is compatible with a wide range of disc types (media) and formats. Playable discs will generally feature one of the following logos on the disc and/or disc packaging. Note however that some disc types, such as record- able CD and DVD, may be in an unplayable format—see below for further compatibility information.

DVD-Video DVD-R DVD-RW

Audio CD Video CD

CD-R

CD-RW

Fujicolor CD

•KODAK Picture CD

• is a trademark of Fuji Photo Film Co. Ltd.

9

En

Image 9

Contents XV-DV9 For XV-DV9 Location Rear of the unitFor XW-DV1WS Operating EnvironmentFollowing does not apply to the Asian and Oceanic models LASERPRODUCTCLASS1Voltage selector For XV-DV9 onlyContents Surround sound and other settings Using the timerVideo Adjust menu Initial Settings menuWidescreen TV users Standard TV users Recording mode Troubleshooting GeneralBefore you start FeaturesBefore you start Chapter What’s in the boxUsing the remote control Disc / content format playback compatibilityBefore you start File format used by digital still cameras Jpeg file compatibilityConnecting up Connecting up ChapterConnecting the speakers and wireless speaker system Connecting up Placing the speakers Before mounting Wall-mounting the center speakerConnecting using the S-video output Connecting up Connecting to your TVConnecting using the component video output Listening to TV audio through this system When TV format is set to PALConnecting up Using this unit with a Pioneer plasma display Using the SR+ mode with a Pioneer plasma displayTo switch SR+ mode on/off, press SR+ Shift + Connecting up Pull off the protective shields of both AM antenna wires Connecting up Connecting the supplied antennasAssembling the loop antenna AM loop antennaFM wire antenna Connecting the powerControls and displays Chapter Controls and displaysFront panel 16 1518 17 16 Controls and displaysSpeaker indicators Timer indicatorsRPT and RPT-1 12 2 PRO Logic IIControls and displays Remote control Tune + Cursor buttons, Enter and tuning buttonsST + QUIET/MIDNIGHTProgram Shift + 1 Timer Shift + 6Repeat Shift + 2 Random Shift + 3Channel indicators Wireless speakerControls and displays Transmitter CH 1 CH 2 CH 3 CHWireless Mode switch Power indicatorTuned indicator Switching on and setting up Getting startedGetting started Chapter Using the Room Setup Setting the clockGetting started Button Setting up the remote to control your TVPlaying discs Getting started Using the on-screen displaysPress OPEN/CLOSE to open the disc tray Load a disc Basic playback controlsResume and Last Memory Using the front panel controlsButton What it does Resume and Last MemoryChanging discs Press Exchange to open the disc trayPress Exchange or OPEN/CLOSE to close the disc tray DVD-Video disc menus Why won’t the disc I loaded play?Listening to the radio Video CD/Super VCD PBC menusImproving poor FM reception Press Enter to save the station presetMemorizing stations Tune to a frequencyListening to station presets Listening to other sourcesSinging karaoke Getting started Using the wireless speaker system Press System SetupSwitch the main unit and wireless speaker back on Front left Center Front right Press Surround to select the ‘Auto’ listening mode Auto listening modeListening to your system Listening to your system ChapterUse the cursor up/down buttons to adjust the setting Dolby Pro Logic II Music settingsListening to your system Listening in surround sound Use the cursor up/down buttonsUsing Front Surround Listening to your system Using the Advanced Surround effectsTo adjust the effect level Listening with headphonesListening in stereo Djusting the Advanced and Front rround effect levelUsing Quiet and Midnight listening modes Listening to your system Enhancing dialogueListening with a virtual surround back speaker Press Sound Mode Listening to your system Adjusting the bass and trebleTo adjust the sound To select ‘Bass’ or ‘Treble’Playing discs Playing discs ChapterScanning discs Using the Disc Navigator to browse the contents of a disc Playing in slow motionFrame advance/frame reverse Looping a section of a disc Using repeat playTo resume normal playback, select ‘Off’ from the menu During playback, press Home Menu and select ‘Play Mode’Select ‘Repeat’ from the list of functions on the left Using random playSelect a repeat play option Select a random play optionPress Home Menu and select ‘Play Mode’ Creating and editing a DVD program listSelect ‘Program’ from the list of functions on the left Select ‘Create/Edit’ from the list of program optionsPress Enter to add the highlighted item to the program list Creating and editing a non- DVD program listAdd further items to the program list in the same way To play the program list, press playProgram Program Step Disc Folder Track Searching a disc Select a search modeOther functions available from the program menu Press Enter to start playbackSwitching DVD audio language Playing discs Switching subtitlesSwitching audio channels when playing a Video CD/ Super VCD Zooming the screenDisplaying disc information Switching camera anglesOSD disc information Front panel display informationViewing Jpeg discs Using the Jpeg Disc Navigator and Photo BrowserViewing Jpeg discs Chapter Playing a Jpeg slideshowUsing the Photo Browser Viewing Jpeg discsUse the cursor buttons Navigate Using the timer Chapter Using the timerSetting the wake-up timer Set the switch-off timeSetting the sleep timer Using the timerTurning the wake-up timer on/off Press Timer Shift + 6 twice to reach the timer menu UseTo check how much time is left, repeat steps 1 Surround sound and other settings Chapter Using the System Setup menuSurround and sound setup options SR+ control options for Pioneer plasma displays Surround sound and other settingsFunction setting for DVD input Setting the channel levelsFunction setting for TV input Function setting for L1 inputWhen you’re done, press Enter to exit test tone setup Video Adjust menu Chapter Video Adjust menuVideo Adjust Creating your own presetsInitial Settings menu Chapter Initial Settings menuUsing the Initial Settings menu Video Output settingsLanguage settings Initial Settings menuDisplay settings SettingOptionRegistering a new password OptionsParental Lock Setting/changing the Parental Lock Changing your passwordSetting/changing the Country code Select ‘Password Change’System Setup menu options in standby Optional system settingsAdditional information Additional information ChapterResetting the system Additional informationWatching Ntsc on a PAL TV MOD. PAL Titles, chapters and tracks Using and taking care of discsDVD Video regions Handling discsHints on installation Proper installation and maintenance of this systemStoring discs Discs to avoidWireless speaker system maintenance and precautions AC adapter and power cord caution Moving the wireless speakerRadio wave reflections Radio wave cautionFor safety in operation Scope of operationStatic electricity Connecting auxiliary components Additional information Connecting external antennasExternal AM antenna External FM antennaPress Sound Mode Use the Use Recording modeButtons to select ‘Rec Mode?’ To select ‘R.Mode On’ or ‘R.Mode Off’Additional information Troubleshooting ProblemRemedyGeneral DVD/CD/Video CD/Super VCD player Problem RemedySound Demo shows STANDBY/ON buttonTuner WMA/MP3/JPEG discsConnecting external antennas on Wireless speaker systemMessage Description Error MessagesAdditional information Screen sizes and disc formats Selecting languages using the language code listWidescreen TV users Standard TV usersCountry code list Additional information Language code listMarantz Additional information Preset code listDolby Digital Additional information GlossaryAdditional information Specifications Wireless speaker Digital Wireless Speaker System XW- DV1WS GeneralAccessories Digital Wireless Speaker System TransmitterPioneer Corporation