RCA VR725HF manual To Audio and Video Dub, To Video Dub Refer to hookup on page 8, Option B

Audio and Video Dubbing

(continued)

To Video Dub (Refer to hookup on page 8, Option B.)

Caution

If you attempt to video dub onto a

blank tape, the video will "break

up" and flash

during playback. Record something

on the blank tape, and then video dub.

1.Connect the two VCRs and turn them on.

2.Tune TV to the VCR viewing channel, either 3, 4, or the TV's video input.

3.Press INPUT on recording VCR to select the line input (L1 or L2). "El" or "L2" appears in the VCR's display panel and "VIDEO 1" or "VIDEO 2" appears on the TV screen.

4.Insert the tape you want to copy into playback VCR. Insert a tape you want to dub with the safety tab in place in the recording VCR.

5.Press PLAY.PAUSE on the recording VCR. When you reach the point on the tape where you want to begin dubbing, press PLAY.PAUSE.

6.Press AoV DUB on the recording VCR's remote until V.DUB appears in the VCR's display panel. The VCR enters the video dubbing mode and V.DUB remains in the VCR's display panel.

7.Press PLAY.PAUSE on the playback VCR. Then press

PLAY.PAUSE. The VCR enters the play-pause mode.

8.Press PLAY.PAUSE on both VCRs at the same time to begin dubbing the tape.*

9.Press STOP.EJECT on the VCR or STOP on the remote when you are finished.

*You can turn off the TV after the dubbing has started as it does not have to be on to dub a tape.

To Audio and Video Dub

1.Connect the dubbing source(s) and follow steps 1- 5 above.

2.Press AoV DUB on the recording VCR's remote until A.DUB and V.DUB appear in the VCR's display panel. The VCR will enter the

audio/video dubbing mode and A.DUB and V. DUB remain in the VCR's display panel.

3.Proceed with steps 7 - 8 above.

The existing video, linear audio, and hi-fi audio will be replaced by the new audio and video.

4.Press STOP.EJECT on the VCR or STOP on the remote when you are finished.

41