Recording | from | Another | VCR | ||||||
To copy (dub) | tapes, | connect the | two | VCR's | as | shown | CAUTION: The unauthorized recording of television | ||
below. | Use shielded | audio/video | cables | (such | as | RCA | |||
programs and other materials may infringe the rights | |||||||||
=AH002 | or | =AH005). |
|
|
|
|
| ||
|
|
|
|
| of others. | ||||
The connections from the recording VCR to your TV are | |||||||||
| |||||||||
the ones you normally use. h is preferable to play the |
| ||||||||
original tape on the same machine that was used to |
| ||||||||
record | it. |
|
|
|
|
|
|
| |
AH002* or AH005*
CABLES
RECORDING VCR
®
AH002* |
| To | VHF antenna | terminal | |
CABLES | OR | ||||
on | conventional | TV | |||
*Optional accessory available from your RCA dealer. |
| ||||
TO audio and video inputs |
|
|
| ||
on TV Monitor/Receiver
Simplified Operating Instructions to Dub Tapes
I. Connect the two VCR's as shown above. (Use
shielded audiolvideo cables such as RCA
#AH002or **AH005.)
2.Turn on TV.
3.Tune TV to VCR Channel (channel 3 or 4).
4.Turn on both VCR's.
5.Insert recorded cassette into PLAYBACKVCR_
6.Insert blank cassette into RECORDING VCR.
7.Press VCR/TV switch on RECORDING VCR
so VCR tight is on, (This allows you to watch the recording while it's in progress0
12.Press PLAY on the PLAYBACK VCR to start playing the prerecorded cassette.
13.Adjust TRACKING control on PLAYBACK VCR if necessary,
Note= If tile prerecorded cassette is not being played on the same VCR that ori_lly
recorded it, streaks may appear in the TV picture. Simply adjust the tracking control on the PLAYB_4CK VCR to eliminate the streaks.
14.If you want to edit out unwanted material, press
PAUSE oa the RECORDING VCR while it is
recording. Press PA USE again to resume
Note: If you want to watch another TV channel on the TV while you're dubbing the tape, first
press the VCRiTV switch so the VCR light is out and then use the TV's channel selector to
select the channel you want to watch on the TV,
8.Make sure the TUNER/LINE switch on the recording VCR is in the LINE position.
9.Select the desired tape speed on the
RECORDING VCR (SP, LP or SLP).
10.Rewind cassettes to the beginning if necessary.
t t, Place the RECORDING VCR into the record mode.
recording.
Note: Use the PA USE button only for brief
pauses. If you want to pause for more than three or four minutes, stop the VCR by pressing
STOP. When you are ready to resume, place the VCR back into the record mode.
15.The TV does not have to be turned on to dub a tape, You may turn off the TV if desired after the recording has started.
16.Stop both VCR's when the recording is finished.
21