Timer Recording
The information on this page tells you how to set up
your VCR for Timer Recording after you have programmed the timer. (The programming instructions are on pages
make one or more short timer recordings for practice so you won't be disappointed later on.
If you have a Daily or Weekly program in the VCR timer, you should check the steps in the drawing sometime before the recording time to be sure that your VCR is ready to record.
Q PROGRAM THE TIMER. (_ INSERT CASSETTE. ///_ REWIND IF NECESSARY.
f
{
/ // l '°'°
| /g ¢ | f¢ "r 4'7 | kl |
c====_ | ,,_.... | ,/ |
|
it/ !
[..7) CHECK DISPLAY.
VCR OFF | _r |
I
"o"/!
TIMER
PROGRAMM_
Timer Recording Checklist
Before your VCR timer can record a TV broadcast, all the conditions listed here must be fulfilled. They are presented as a checklist you can use until you are familiar with your VCR.
[] Cassette inserted in the VCR. (TIMER flashes if not.)
[] Cassette has its safety tab in place. (If not, the cassette is ejected.) (See "Erase Protection" on page
/CORRENTOAY
CORRENTT,ME
is to remind you to insert a new cassette or cover the safety tab.
XPR and Timer
The timer cannot begin recording if the VCR is already recording with XPR, and vice versa. You can use XPR along with Timer Recording, but be careful that the XPR recording will end before the first timer recording begins.
9.)
[] Cassette length and recording speed are adequate for program(s) to be recorded.
[] Cassette rewound to beginning or to place desired on tape.
[] Clock set to correct time and date.
[] Timer has been programmed. ("PROG" will be displayed.)
[] POWER has been turned off. "TIMER" appears only if the timer is programmed and the VCR is off.
Programming Reminders
•The timer light will flash when you turn off the VCR
if you have programmed the timer but forgotten to insert a cassette.
•If the cassette, in the VCR has its safety tab removed (page 9), the VCR will eject it after you have programmed the timer and turned off the VCR. This
TV Viewing During a Timer Recording
When the VCR turns on automatically to make a timer recording, it does not disturb whatever program you may be watching at the time. Press the VCR/TV switch to turn on the VCR light if you want to monitor the
recording.
Stopping a Timer Recording in Progress
Press POWER and then press STOP within 10 seconds. (Press POWER once more to turn off the VCR). This erases a Normal program from the timer's memory, but a Daily or Weekly program will record on the next scheduled day.
Timer Recording From the Line Input
It is also possible to timer record from the VCR's Line input. Just enter "91" for the channel. This is particularly convenient if you have a satellite receiver or similar device attached to the VCR's Line input.
26