CONNECTIONS
THINGS TO KNOW BEFORE
CONNECTING COMPONENTS
Protect Your Components from Power Surges
•Connect all components before plugging any power cords into the wall outlet.
•Always turn off the TV and other components before you connect or disconnect any cables.
Position Cables Correctly to Avoid Audio Hum or Interference
•Insert all cable plugs firmly into their jacks.
•Place the audio/video cables to the sides of the TV’s back panel instead of straight down the middle after you connect your components.
•Try not to coil any
•Make sure all antennas and cables are properly grounded. Refer to the Safety Tips sheet packed with your unit.
Protect Your Components from Overheating
•Do not block ventilation holes in any of the components. Arrange the components so that air can circulate freely.
•Do not stack components.
•Allow adequate ventilation when placing your components in a stand.
•Place an amplifier or satellite receiver on the top shelf of the stand so heated air rising from it will not flow around other components.
1 FIRST THINGS FIRST
➣
2 SETTING UP THE VCR
➣
3 VCR BASICS
➣
4 RECORDING
➣
5 PROGRAMMINGREMOTE THE
➣
6 CONNECTIONS
35