Pioneer DVR-320 Handling discs, Storing discs, Damaged discs, Cleaning the pickup lens

Page 100

13Additional information

Message

There is no DV input or the input signal is unre- cordable.

Cannot preview because there is no DV input or the input signal is unrecordable.

Explanation/Action

No signal was detected at the DV input/output jack. This may appear if a blank section of DV tape is playing in the connected camcorder. (Applicable to DVR-320 only.)

This channel’s TV system is different from the recorder’s setting.

Recording failed due to a TV system mismatch. Press DISPLAY to clear message.

Playback has stopped because the TV system is different than the recording.

The TV system (PAL, NTSC, etc.) of the current channel is different from the TV system settings of this recorder.

The timer recording failed because the TV system of the channel set for recording was different from the setting of the recorder.

During recording or timer recording standby, the TV System (PAL, NTSC, etc.) of the playback video changed, causing playback to stop automatically.

Handling discs

When holding discs of any type, take care not to leave fingerprints, dirt or scratches on the disc surface. Hold the disc by its edge or by the center hole and edge.

Damaged or dirty discs can affect playback and recording performance. Take care also not to scratch the label side of the disc. Although not as fragile as the recorded side, scratches can still result in a disc becoming unusable.

For more detailed care information see the instructions that come with discs.

Do not load more than one disc into the recorder.

Should a disc become marked with fingerprints, dust, etc., clean using a soft, dry cloth, wiping the disc lightly from the center to the outside edge as shown in the diagram below.

If necessary, use a cloth soaked in alcohol, or a commercially available CD/DVD cleaning kit to clean a disc more thoroughly. Never use benzine, thinner or other cleaning agents, including products designed for cleaning vinyl records.

Storing discs

Although CDs and DVD discs are more durable than vinyl records, you should still take care to handle and store discs correctly. When you're not using a disc, return it to its case and store upright. Avoid leaving discs in excessively cold, humid, or hot environments (including under direct sunlight).

Don't glue paper or put stickers onto the disc, or use a pencil, ball-point pen or other sharp-tipped writing instrument. These could all damage the disc.

Damaged discs

Discs spin at high speed inside the recorder. If you can see that a disc is cracked, chipped, warped, or otherwise damaged, don't risk using it; you could end up damaging the recorder.

This recorder is designed for use with conventional, fully circular discs only. Use of shaped discs is not recommended for this product. Pioneer disclaims all liability arising in connection with the use of shaped discs.

Cleaning the pickup lens

The DVD recorder’s lens should not become dirty in normal use, but if for some reason it should malfunction due to dust or dirt, consult your nearest Pioneer- authorized service center. Although lens cleaners for CD players are commercially available, we do not reco- mmend using them since some may damage the lens.

100

En

Image 100
Contents DVR-220DVR-320 LASERPRODUCTCLASS1 POWER-CORD Caution Operating EnvironmentContents Resetting the recorder Setting up the remote to control your TVAdditional information IndexBefore you start FeaturesBefore you start Chapter Before you start Using the remote control Putting the batteries in the remote controlBefore you start What’s in the box General disc compatibility DVD-R/RW compatibilityCD-R/RW compatibility Compressed audio compatibilityJpeg file compatibility WMA Windows Media Audio compatibilityPC-created disc compatibility Original Connecting up Connecting up ChapterRear panel connections Front panel connectionsConnecting up Extra features for use with compatible TVs Connecting up Easy connections Connecting up Using other types of audio/video output Connect the Video Output jack to a video input on your TVThis enables you to watch and record TV channels This enables you to watch discsThis enables you to record scrambled TV channels Connect RF antenna cables as shownConnecting up Connecting an external decoder box Scart AV Connector Connecting up Connecting to an AV amplifier/receiver This enables you to listen to multichannel surround soundConnecting up Connecting other AV sources PluggingControls and displays Controls and displays ChapterFront panel STANDBY/ONControls and displays Display Controls and displays Remote control AudioSubtitle AngleControls and displays Switching on and setting up Getting startedGetting started Chapter EnterGetting started Other settings you can make Select the TV screen type, ‘Standard 43’ or ‘Wide 169’Connected, or Not Connected, then press Enter Digital, Dolby Digital, DTS or PCM only, then pressUsing the built-in TV tuner Getting started Making your first recordingPlaying back your recording Changing TV channelsSwitching between TV and DVD Basic playbackChanging audio channels NicamPress STANDBY/ON to switch on Playing DVD discsPress OPEN/CLOSE to open the disc tray Load a disc To stop playback, press StopPlaying CDs and WMA/MP3 discs Playing Video CD/Super VCDsUsing the Home Menu Displaying disc information on- screenStop display UsePlay display Recording displayRecording mode Using the Disc Navigator to browse the contents of a disc PlaybackPlayback Chapter IntroductionUsing the Disc Navigator with recordable discs PlaybackChanging the thumbnail picture for a title Select ‘Play’ from the menu optionsNavigating discs Scanning discsScan 1 Scan 2 Scan 3 Scan Scan Scan 2 ScanPlaying in slow motion Frame advance/frame reverseSlow 1/2 PressPlayback Play Mode menu Search ModePlay Mode RepeatRepeat play Program playOther Program play functions Repeat to build up a program listSwitching DVD soundtracks Playback Displaying and switching subtitlesClear Playback Switching audio channels Switching camera anglesTo display/switch the audio channel, press Audio repeatedly To switch the camera angle, press AngleRecording Recording ChapterAbout DVD recording Recording time and picture qualityRecording Restrictions on video recording Setting the picture quality/recording timeRecording equipment and copyright Recording Basic recording from the TV Load a recordable discFront panel display shows the channel number Use the Audio button to select the audio channel to recordRecording Setting a timer recordingDirect recording from TV Easy Timer Recording Press Easy TimerSet the TV channel and recording quality Current time Recording start timeStandard timer recording Press Timer REC to display the Timer Recording screenEnter the timer recording settings Press Enter to set the end timeTimer recording using the Video Plus+ programming system To exit the timer recording screen, press Home MenuVideo Plus+ programming with the power off Extending a timer recording in progressLUS Code NextMoving the end time by 30-minute blocks Canceling and stopping a timer recording in progressProgramming a new end time Recording Timer recording FAQ You can’t enter a timer program if the clock isn’t setSee Connecting up for connection options Simultaneous recording and playbackSet up the recorder Press REC when you’re ready to start recordingSee Audio In settings on page 83 for more on these settings Automatic recording from a satellite tunerAlso, set the camcorder to VTR mode Recording from a DV camcorder DVR-320 onlyAV2/L1 In is set to Decoder see AV2/L1 In on Press Home Menu and select ‘DV Record’ from the menuPlaying your recordings on other DVD players Recording from the DV output DVR-320 onlyFinalizing a disc Press Home Menu and select ‘Disc Setup’ Select ‘Finalize’ How to change the recorder’s settingPress Home Menu and select ‘Disc Setup’ Select ‘Initialize’ Initializing a DVD-RW discEditing Chapter EditingDisc Navigator screen Editing Playlist / Original indicatorDisc Navigator menu options Editing Editing VR mode Original and Video mode content PlayErase Title Name Ttl NameUsing the remote key shortcuts to input a name Chapter Edit Chpt EditEditing Key Characters ’ ?Inserting chapter markers into a title Erase Section Erase SecSelect ‘Erase Sec’ from the Disc Navigator menu options Use TitleLock / Unlock Erase AllUndo This erases all unlocked titles from the disc see also LockYou can give titles new names of up to 64 characters long Editing Creating and editing a VR mode Play ListPress Enter after selecting each character Input a name on Create Original title to put into the Play ListDivide MoveCombine Press Enter to add the titleThis command erases all the titles from the Play List Select ‘Undo’ from the Disc Navigator Play List menu optionsDisc History Using the Disc HistoryDisc History Chapter PhotoViewer PhotoViewer ChapterPlaying a slideshow Reloading files from a discZooming the screen PhotoViewerRotating the screen Disc Setup menu Disc Setup menu ChapterBasic settings Press Home Menu and select ‘Disc Setup’Initialize settings Disc Setup menuFinalize settings Video/Audio Adjust menu Video/Audio Adjust menu ChapterSetting the picture quality for TV and external inputs Choosing a presetSetting the picture quality for disc playback Video/Audio Adjust menuSelect the picture quality setting you want to adjust Black Setup setting applies only when playing Ntsc discs Audio DRCInitial Setup menu Initial Setup menu ChapterUsing the Initial Setup menu Clock SettingInitial Setup menu Power SaveInput Line System On Screen DisplayTuner settings Remote Control SetSetup Navigator Auto Channel Setting Auto ScanAuto Channel Setting Download from TV Manual CH SettingChannel Swapping Set Video Plus+ CHInitial Setup menu Video In / Out settings Input Colour SystemAV1 Out AV2/L1Audio In settings Ntsc on PAL TVNicam Select Tuner LevelAudio Out settings Language settings Default setting w/Subtitle Language Subtitle LanguageAuto Language DVD Menu LanguageRecording settings Selecting ‘Other’ languagesManual Recording Optimized RecPlayback settings Parental Lock Set Password Parental Lock Change PasswordSeamless Playback Parental LockParental Lock Change Level Parental Lock Country CodeAngle Indicator Resetting the recorder Setting up the remote to control yourUsing the TV remote control buttons Additional informationWhen viewing on a widescreen TV or monitor When viewing on a standard TV or monitorAdditional information Screen sizes and disc formats Problem Remedy Additional information TroubleshootingGeneral Additional information Frequently asked questions Problem Additional information About DV DVR-320 only DV-related messagesAdditional information Language code list Country code listLanguage Language code letter, Language code Country, Country code, Country code letterMessage Cleaning the pickup lens Handling discsStoring discs Damaged discsHints on installation Additional information CondensationManual recording modes Moving the recorderAdditional information Glossary Mpeg video Optical digital outputPCM Pulse Code Modulation PBC PlayBack Control Video CD/Super VCD onlyAdditional information Specifications TimerTuner Input/OutputAV Connectors 21-pin connector assignment Supplied accessoriesPIN no Index Video mode 7, 9, 10, 22, 34, 44, 56, 57, 60, 73, 88, 96 Pioneer Corporation VRB1335-A