Tuner settings, Remote Control Set | Pioneer DVR-520H, DVR-720H

The Initial Setup menu

•Mode1 – Through function only for the antenna terminal

•Mode2 – No through function

•Off – Through function for both antenna terminal and AV connector

Note

•When a timer recording is set with VPS/PDC on, SCART through is always active.

Remote Control Set

• Default setting: Recorder1

You only need to set this if you are using more than one Pioneer DVD recorder in the same room.

Initial Setup
Basic	Clock Setting	Recorder1
Tuner	Input Line System	Recorder2
Video In/Out	On Screen Display	Recorder3
Audio In	Front Panel Display
Audio Out	Power Save
Language	Remote Control Set
Recording	Setup Navigator
Playback

So that each remote control operates only its own recorder, make this setting different for each recorder and remote in the room.

There are three different recorder IDs. When set to Recorder2 or Recorder3, the remote control mode is shown in the front panel display.

After selecting a new recorder ID, you have to confirm the

change by selecting Yes or No (use the (cursor left/right) buttons), then pressing ENTER.

Note that as soon as you change the recorder ID, the remote becomes inoperative until you change the remote to the same ID.

To set the remote, press and hold RETURN and a number button (1, 2 or 3) until the indicator on the remote lights.

Setup Navigator

• Default setting: n/a

Initial Setup
Basic	Clock Setting	Start
Tuner	Input Line System
Video In/Out	On Screen Display
Audio In	Front Panel Display
Audio Out	Power Save
Language	Remote Control Set
Recording	Setup Navigator
Playback

The Setup Navigator appears automatically when you switch on the recorder for the first time (or after resetting the recorder). It is also available from the Initial Settings menu should you need it at any other time.

See also Switching on and setting up on page 25.

Tuner settings

Auto Channel Setting : Auto Scan

This recorder has a built-in TV tuner for recording PAL B/ G, PAL I, SECAM L and SECAM D/K TV programs off the air or from analog cable TV. We recommend that you first use the Auto Channel Setting described here to tune into the channels in your area, then if there are any unwanted channels, you can disable them using Channel Skip (described below).

1Choose ‘Tuner’ from the Initial Setup menu, then ‘Auto Channel Setting’, then ‘Auto Scan’.

Initial Setup
Basic	Auto Channel Setting	Auto Scan
Tuner	Manual CH Setting	Download from TV
Video In/Out	Channel Swapping
Audio In	Set VIDEO Plus+ CH
Audio Out
Language
Recording
Playback

2Select your country then press ENTER to start tuning.

Initial Setup
Basic	Autto Auto Channel Setting
Tuner	Manual
Video In/Out	Channel Country	UK
Audio In	Set
Audio Out
Language
Recording
Playback

•You can cancel before auto tuning has finished by pressing ENTER again.

After auto scanning has finished, the channel mapping screen appears showing which channels have been assigned to which program numbers.

	Initial Setup
Channel Mapping					1/7
Pr	System	CH Name	Pr	System	CH Name
1	I	26	9	I	9
2	I	33	10	I	25
3	I	23	11	I	11
4	I	30	12	I	12
5	I	37	13	I	13
6	I	35	14	I	14
7	I	39	15	I	15
8	I	26	16	I	16

Use the PREV/NEXT buttons to display the previous/next page.

3 Press HOME MENU to exit this screen.