05Preparation
Preparing the remote control unit
Inserting batteries
1Open the battery cover.
2Insert the supplied two AAA (1.5 V) size batteries.
•The battery polarities must correspond with the (+) and
3Close the battery cover.
Cautions regarding batteries
•The remote control unit cannot operate the system if the batteries in the unit are empty. When this happens, replace the batteries with new ones.
•Do not use manganese batteries. When you replace the batteries, use alkaline ones.
•Do not mix batteries of different types. Different types of batteries have different characteristics.
•Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.
•Do not leave dead batteries in the remote control unit; chemical leakage will occur. If you find any chemical leakage, wipe thoroughly with a cloth.
•The batteries supplied with this product may have a shorter life expectancy due to storage conditions.
•If you will not use the remote control unit for an extended period of time, remove the batteries from it.
•WHEN DISPOSING OF USED BATTERIES, BE SURE TO COMPLY WITH GOVERNMENT REGULATIONS AND ENVIRONMENTAL PROTECTION GUIDELINES THAT APPLY IN YOUR COUNTRY OR AREA.
Allowed operation range of the remote control unit
Operate the remote control unit while pointing it toward the remote control sensor located at the bottom center of the front panel of the Plasma Display. The distance from the remote control sensor must be within 7 m (23 feet) and the angle relative to the sensor must be within 30 degrees in the right or left direction.
POWER
30°
|
| STAN D B Y |
|
|
|
|
|
| DTV | TV |
|
|
|
|
|
| VCR | DVD |
| |
|
|
|
|
| HDMI | |
|
|
|
|
|
| STANDBY |
|
|
|
|
|
| /ON |
| (23 | feet) |
|
|
|
|
m |
|
|
|
|
| |
|
|
|
|
|
| |
7 |
|
|
|
|
|
|
Remote control
30° sensor
16
En
16 | 05.4.20, 4:30 PM |