RCA PHD42600 manual Programming the Remote to Operate Other Components, Using the Input Button

Using the Remote Control

Using the INPUT Button

Use the INPUT button to scroll through the available video input channels and view components you have connected to the monitor.

1.Make sure the component you want to view is turned ON.

2.Press INPUT to tune to the video input channel that corresponds to the jack on the monitor you used to connect the component.

3.To return to the previous channel, continue pressing INPUT.

	VCR1		ON•OFF		MONITOR
	DVD	VCR2 AUX			SAT•CABLE
Component						ON•OFF
	MUTE				CINEMA	button
buttons			CH +
	L				V
	O				O
	V
					L
	A		CH –
	AUTO SET				GO BACK
	GUIDE				INFO
			OK
			ZOOM			CLEAR
	MENU				CLEAR	button
	1	2		3
	4	5		6
	7	8		9
	INPUT	0		ANTENNA
REVERSE
	REVERSE		PLAY	FORWARD
and PLAY	RECORD		STOP		PAUSE
buttons	REPEAT	AUDIO ANGLE OPEN
			DVD			STOP
						button
	u n	i	v e r	s	a l

You’ll use these buttons when programming the remote.

Important: The remote may not be compatible will all models of all brands of components. It may also not operate all functions of the remote that came with your component.

Programming the Remote to Operate Other Components

The universal remote can be programmed to operate most brands of remote controllable components. The remote is already programmed to operate most RCA, GE, and Proscan components.

Note: The MONITOR button can’t be programmed on this remote.

Find Out If You Need to Program the Remote

To determine whether the universal remote needs to be programmed for your component, turn the component ON. For example, to program the remote for a VCR, turn on the VCR. Point the remote at the VCR, and press the VCR1 button. Then press ON•OFF or CH + (channel up) or CH – (channel down) to see if the VCR responds to the remote commands. If the component does not respond, the remote needs to be programmed.

Programming the Remote

There are two ways to program the remote control:

•automatic code search

•direct entry

Using Automatic Code Search

The following instructions can be used to program the remote to operate each of your components. If you want to stop the automatic code search without programming any of your components, press CLEAR until the indicator on the remote turns off.

1.Turn on the component you want to operate (VCR, DVD player, etc.)

2.Press and hold the component button you want to program (VCR or DVD, etc.). While holding the component button, press and hold ON•OFF until the indicator on the remote turns on, then release both buttons.

Note: You can also use Automatic Code Search to program the AUX button for audio components.

3.Point the remote at the component. Press and release PLAY, then wait 5 seconds or until the indicator on the remote stops flashing.

continued on next page

Chapter 2 Graphics contained within this publication are for representation only. 15