RCA L50000 manual Programming the remote to Operate Components, How to program the remote

Chapter 3 The Remote Control

Display window

	DIRECTV	ON•OFF		TV
	VCR			DVD
	1
	VCR			AUX
	2	AUD
	M1			M3
Component		M2
	L1			L3
buttons and		L2		FRONT
ON•OFF button	MUTE			SKIP
		CH +
	VOL -			VOL +
	REAR	CH -		CENTER
	FORMAT			GO
				BACK
	TEST			AM•FM	The backlight
	GUIDE			INFO	button
The OK
	LEVEL -	OK		LEVEL +
button	MENU			CLEAR	The up arrow
	PROGRAM				button
	1	2		3
	4	5		6
The down	7	8		9
arrow button	INPUT	0		ANT
				FUNCTION
	REV	PLAY		FWD
	REC	STOP		PAUSE
		SWAP	CH
	PIP		CTRL	WHO
		DELAY
	DSP			DSP
	ON•OFF			MODE

How to Stop Programming

To exit programming mode, press the CLEAR button at any time (EXIT SETUP appears in the remote’s display to confirm that no new codes have been entered).

Programming the remote to Operate Components

Your remote control can be programmed to operate most brands of remote- controllable VCRs, audio components, DVD players, cable boxes, and many other components. In addition to being programmed to operate your LCOS television, it’s already programmed to operate most RCA, GE, and Proscan VCRs, DVD players, satellite receivers, and laserdisc players.

Find out if you need to program the remote

To determine whether your remote needs to be programmed to operate one of the components connected to your TV, such as a VCR, do the following:

1.Turn on the component (in this example, a VCR).

2.Point the remote at the component.

3.Press the corresponding component button (in this example VCR1).

4.Press ON•OFF to see if the component responds. If the component doesn’t respond, you need to program the remote to operate it.

How to program the remote

There are three ways to program your remote control: automatic code search, manual code search, and direct entry (instructions are described next).

Notes:

•If approximately 30 seconds passes before a button is pressed, the display window stops transmission to conserve battery life. If this occurs, restart from step 1.

•To exit programming mode, press the CLEAR button at any time (EXIT SETUP appears in the remote’s display to confirm that no new codes have been entered).

44