Using the Remote Control
If the component you want to control does turn off:
1.Press and release REVERSE, then wait 2 seconds. Repeat this step until the component turns back ON.
2.To finish, press and hold STOP until the indicator on the remote turns off.
Using Direct Entry
1.Turn on the component to be programmed.
2.Look up the brand and code number(s) for the component on the code list in this section.
3.Press and hold the component button you want to program on the remote.
4.Enter the
5.Release the component button.
6.Point the remote at the component. Press ON¥OFF to see if the component responds to the command. If it doesnÕt, try pressing the component button and then ON¥OFF again.
¥If you get no response, repeat these steps using the next code listed for your brand, until the component responds to the remote commands.
¥If you try all the codes for your component brand and none work, try the automatic code search method. If automatic code search doesnÕt find the code, the remote is not compatible with your component.
How to Use the Remote After You’ve Programmed It
Because this universal remote can control several different components (TV, DVD, VCR, satellite receiver, etc.) it uses operational modes triggered by the component buttons. For example, if you want the remote to control the TV, you would press the TV button to put the remote into TV mode before you could control the TV.
1.Press the appropriate component button (DVD, TV, VCR1, VCR2, SAT¥CABLE, AUX) to set the remote to control the component.
2.Press ON¥OFF to turn the component ON or OFF.
3.Use the remote buttons that apply to that component.
Note: If you keep pressing buttons and nothing happens, the remote is probably in the wrong mode. You must press the component button that matches the component you want to operate (i.e., if you want to operate the VCR, press VCR1 on the remote control to put the remote in VCR mode.)
Chapter 2 | Graphics contained within this publication are for representation only. | 15 |