Other Information
¥CRI ON'OFF W
DVD VCR_ _IJX SAI.CAllLE
MUTEZOOM
Universal Remote
The universal remote can be programmed to control most brands of remote controllable TVs, VCRs, satellite receivers and cable boxes. The remote is already programmed to control most RCA, PROSCAN, and GE TVs, VCRs, and satellite receivers.
The AUX button can be programmed to control most brands of an additional remote controllable TV, VCR, satellite receiver, or cable box.
GUIDEtRFQ
ME;4UCLEAR
"0,0 °©
INPU1
© o,0 O
REVERSE pLAy FORWARD
REGORD STOP PAUSE
OPE_CLOSE
OOOO
_,lmll_.E auom _QLE F_E
The remote may not operate all models of all brands.
Test the Remote
To determine whether the universal remote needs to be programmed,
turn a device ON, such as a VCR. Point the remote at the VCR, and press the VCR1 button. Then press
Program the Remote
There are two ways to program the remote control:
•automatic code search
•direct entry
Automatic Code Search
The following instructions can be used to program the remote to operate each of the components connected to your DVD Player. If you want to exit the automatic code search without programming any of your components, press CLEAR until the red light on the remote turns off.
1.Turn on the component you want to operate (VCR, TV, etc.)
2.Press and hold the component button you want to program (VCR1, VCR2, etc.). While holding the component button, press and hold
. Point the remote at the component. Press and release PLAY, then wait 5 seconds or until the red light on the remote stops flashing.
At this point the remote is searching for the correct code to program. If, after 5 seconds, the component you want to operate does not turn off, press PLAY again to tell the remote to search the next set of codes.
Continue pressing PLAY until the component turns off or you have searched through all of the codes. There are 20 total sets of codes. If the component does not turn off after pressing PLAY 20 times, then the remote cannot can't be programmed to operate that component.
94 | Chapter 7 |