Sub Brightness Setting
Equipment required: NTSC grayscale pattern Generator
Panel Settings; Picture = Normal, Aspect Ratio = 16:9
Pattern Display:
Note: Adjust in a Dark room.
Step 1- Set the white balance to Cool.
Step 2- Access the All cutoff setting in service mode and adjust so that pixel emission starts in the 2% area and there is no emission in the 0% area. Step 3- Write down all cut off data.
Step 4- Set the white balance to Normal.
Step 5- Adjust all the cut off values to the same data values of the Cool mode settings.
Step 6- Set the white balance to Warm.
Step 7- Adjust all the cut off values to the same data values of the Cool mode settings.
Step 8- Apply the same pattern to the PC input. Step 9- Repeat steps
Step 10- Apply the grayscale pattern to the RGB input. Step 11- Repeat steps
Step 12- Apply a 525i grayscale pattern to the component input. Step 13- Repeat steps
Step 14- Change to a 525p signal. Step 15- Repeat steps
Step 16- Change to a 625i signal. Step 17- Repeat steps
92