Panasonic TX-20LA2A, TX-20LA2X, TX-20LA2M Manual tuning via top panel, Access Manual tuning

Tuning

Manual tuning

It is possible to retune individual programme positions:

Press the MENU button.

Move to choose Setup menu.

Access Setup menu.

Move to choose Tuning menu.

Access Tuning menu.

Move to choose Manual tuning.

Access Manual tuning.

Select the programme position to be tuned.

Press repeatedly until required station is found.

When the desired station is found, press the OK button to store. The programme position will flash.

Press the TV/AV button at any time to go back to watching TV.

MENU

OK

1 2 3

4 5 6

7 8 9

0

	TV
	Example: TX-20LA2M
	10
	CH10
		Programme down/up
OK	Store	Search down/up
	Return	Exit

Manual tuning

TV/AV

Manual tuning (via top panel)

It is also possible to use the control panel buttons on the top of the TV to tune individual programme positions:

Press F until Tuning mode is reached.

Press –/ or +/ to access Tuning mode.

Press F until Manual tuning is reached.

Press –/	or +/ to access Manual tuning.
Press TV/AV to move between Change programme, Search
and Change sound system.		Example: TX-20LA2M
Press –/	or +/ to change programme position or start search.	10
		CH10
		4. 5MHz
When the desired station is found, press STR to store.		Manual tuning
		-, +	: Search
The programme position will flash.		TV / AV	: Move cursor
		STR	: To store
Repeat above procedure to tune additional programme positions.		F	: To exit
Press F at any time to exit the Tuning menu.		STR	F - / + / TV / AV

Notes:

•If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the Colour system selection on page 12.

•After the Manual tuning is finished, press the Programme Number up button to confirm the tuning condition for each Programme Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers. Please refer to the Skip function on page 12.

•When using a VCR without video and audio input / output terminals, it is convenient to connect the aerial cable as indicated in the instruction manual of VCR and to set the designated channel to Programme No.“0”. In that case, perform Manual tuning after setting the Colour system and Sound system in advance. Further, in multi-system VCR, it is more convenient to set the designated channel to several Programme Numbers.

15