FAQs
Problem | Actions |
●Due to the digital reception technologies involved, quality of the Digital TV signals may be relatively low in some cases, despite good reception of Analogue TV channels.
•Install an aerial individually for the TV and VCR (or use a splitter).
Digital TV
Unable to receive signals with a high-performance aerial
TV
|
| (Individual aerial) |
|
| Splitter |
Aerial | Aerial Output |
|
|
| |
Input | Aerial Output | Aerial Input |
terminal |
|
VCR | (Individual aerial) |
|
Interference or frozen / disappearing image in Digital TV
●Check “Digital TV Signal Condition”. (p. 37)
If “Signal Quality” or “Signal Strength” are displayed in red, check aerial. If problem persists, consult your local Panasonic dealer.
●Turn the TV off with the Mains power On / Off switch, then turn it On again.
●Remove the mains plug of the tuner box from the wall socket and connect it again to turn it on.
Other
TV goes into “Standby mode” | ●Off Timer function is activated. |
●The TV enters “Standby mode” about 30 mins. after analogue | |
| broadcasting ends. |
|
|
| ●Are the batteries installed correctly? (p. 8) |
| ●Has the TV been switched On? |
The remote control does not | ●Has the remote control been registered? (p. 41) |
●The batteries may be running low. Replace them. | |
work or is intermittent | ●Use the remote control within the range of 7 m from the tuner box. |
| ●Keep the remote control away from the devices such as wireless |
| LAN, microwaves, mobile phones or other electric equipment to |
| avoid wave interference. |
|
|
Cannot operate the TV | ●Turn the display unit and the tuner box off, and then on again. |
Parts of the display unit or the tuner box become hot
●The temperature rises will not cause any problems in terms of performance or quality.
60