Select a scanning mode p, Select Edit | Panasonic TC-P54V10 instruction

Automatically searches and adds available channels to the memory.

Select “ANT in”

Select Cable or Antenna

Or select “Not used” (p. 16).

Select “Auto program”

ANT/Cable setup		next
ANT in	Cable	next

	Auto program
	Manual program	select
	Signal meter	select
	Signal meter

Select a scanning mode (p. 17)

	Auto program	ok
	All channels	ok
	All channels
	Analog only	select
	Digital only	select

Settings are made automatically

After the scanning is completed, select “Apply”. (see below ).

All previously saved channels are erased.

Use this procedure when changing the channel setup or changing the channel display.

Also, use this to add or skip channels from the channel list manually.

You can select a channel tuning mode (Digital only/ Analog only) in “Channel surf mode” (p. 36)

Select “Edit”

Manual program

Edit

Apply

Cancel

...

Yes

select

Channel

Caption

Favorite

Add

...

Yes

...

Yes

...

Yes

Select the item to be edited

select the item

Manual program

to edit (Caption/

Edit

Apply

Cancel

Channel

Caption

Favorite

Add

Favorite/Add)

...

Yes

...

Yes

...

Yes

...

Yes

...

avorite

• Caption:

...

Yes

Caption...

...

AddYes

...

Yes

•

Changes the station identifier

...

Yes

Select

RETURN

Favorite:

Prev.page

Registers channel to Favorite

•

List

Add:

Proceed to

Adds or skips channels

Go back to previous page

Edit

Caption

Edit CH caption			select
Edit CH caption
Channel		80-101	change	or
Caption		---	change	or
Caption		---	set/next
	OK		set/next
	OK
Change	RETURN
G ABC → abc	Y Delete

Caption

Select the station identifier (maximum 7 characters available)

Favorite

Set favorite	1/3	select

126-1

next Set favorite Select the number

Add

Press OK to select “Yes (add)” or “No (skip)”

Move cursor to channel number

Manual program					select
Edit	Apply		Cancel		select
Edit	Apply		Cancel
Channel	Caption		Favorite	Add	Press OK to tune
2	...		...	Yes	Press OK to tune
3	...		...	Yes	to the channel.
Select “Apply”
program					select “Apply”
Apply			Cancel		select “Apply”
Apply			Cancel
el Caption		Favorite		Add
...		...		Yes	ok
					ok

Editing and Setting Channels

Advanced

To cancel the Edit

Manual program					Changes will be lost. Continue?		ok
Edit	Apply	Cancel			Yes	No	ok
2	...	...	Yes	select	Yes	No	(returns to “ANT/
Channel	Caption	Favorite	Add
3	...	...	Yes	next			Cable setup”)
4	...	...	Yes	next			select “Yes”
5	...	...	Yes

Check the signal strength if an interference is found or freezing occurs on a digital image.

Signal meter

Channel1-1

Tune manually

Signal strength

Current		30%

Peak level		45%

Signal intensity

If the signal is weak, check the antenna. change If no problem is found, consult your local dealer. channel

ok Note

Not available if “Cable” is selected in “ANT in” (see above).

Available only for digital antenna channels.

If “Lock” (p. 48) is activated and “ANT/Cable setup” is selected, “Enter password.” will be displayed.

Select “ANT in”

Select “Auto program”

Select a scanning mode (p. 17)

Select “Edit”

Select the item to be edited

Edit

Caption

select

select

Move cursor to channel number

Select “Apply”

To cancel the Edit

Signal strength

Peak level

45%

ok Note