Panasonic DMR-ES15 Timer recording, Using G-CODEsystem to make timer recordings, Press G-Code

Timer recording

e.g., Australia and N.Z.

Numbered buttons

G-Code

PROG/CHECK

e,r,w,q

ENTER

REC MODE

RAM -R -R DL -RW(V) +R +R DL +RW

See also the notes “Important notes for recording” (Ô page 14).

Preparation

•Turn on the television and select the appropriate video input to suit the connections to this unit.

•Check the time on the unit is correct.

•Insert a disc (Ô page 16).

For Australia and N.Z.

G-CODEis a registered trademark of Gemstar Development Corporation. The G-CODEsystem is manufactured under license from Gemstar Development Corporation.

RQT8317

For Australia and N.Z.

Using G-CODEsystem to make timer recordings

Entering G-CODEnumbers is an easy way of timer recording. You can find these numbers in TV listings in newspapers and magazines.

• You can enter up to 16 programmes up to a month in advance.

1 Press [G-Code].

G-Code		Remain	1:57	SP
Record	8:12:34			7. 5. SUN

Input G-Code Number 0-9, and press ENTER.

ENTER	0 --9 Number
RETURN

2 Press the numbered buttons to enter the G-CODEnumber.

• To correct the number

Press [w] to move back to correct a digit.

3 Press [ENTER].

Timer			Remain	1:57	SP
Recording			8:14:56		7. 5. SUN
Name	Date	Start	Stop	Mode
1 ARD	7. 5. SUN	19:00	20:00	SP
			Programme Name

• Confirm the programme and make corrections if necessary using [e,r,w,q] (Ô page 19, Manually programming timer recordings, step 3).

• When “––––” appears in the “Name” column, you cannot set timer recording. Press [e,r] to select desired programme position. After you have entered the information of a TV station, it is kept in the unit’s memory.

• You can also press [REC MODE] to change the recording mode.

• To enter programme name

Press [w,q] to select “Programme Name” and press [ENTER] (Ô page 35).

4 Press [ENTER].

The settings are stored and the programme goes to timer recording standby.

The timer icon is displayed in left column.

	Timer
	Recording
Timer icon	No.	Name
	01	ARD

“z” lights on the unit’s display to indicate timer recording standby has been activated.

	No.	Name	Date	Start	Stop	Mode	Drive
							space	When “!” appears,
01		ARD	7. 5. SUN	19:00	20:00	SP	OK
			New Timer Programme					make sure the
								disc has a
								sufficient space.

Repeat steps 1–4 to programme other recordings.

nTo cancel recording when recording has already begun (Ô page 20)

nNotes on timer recording (Ô page 20)

To exit the timer recording list

Press [PROG/CHECK].

18