Panasonic TH 37PWD4 Remote Control Batteries, Helpful Hint, Precaution on battery use

Page 8

Remote Control Batteries

Requires two R6 batteries.

1.Turn the transmitter face down. Press and slide off the battery cover.

2.Install the batteries as shown in the battery compartment. (Polarity + or – must match the markings in the compartment).

3.Replace the cover and slide in reverse until the lock snaps.

Two "R6" size

Helpful Hint:

For frequent remote control users, replace old batteries with

Alkaline batteries for longer life.

Precaution on battery use

Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.

Observe the following precaution:

1.Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.

2.Do not combine a used battery with a new one.

3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.

8

Image 8

Contents English Operating InstructionsWide Plasma Display Dear Panasonic Customer Trademark CreditsTable of Contents Important Safety Notice When using the Plasma Display Safety PrecautionsSetup If problems occur during use Cleaning and maintenanceSafety Precautions Accessories Accessories SupplyOptional Accessories Check that you have the accessories and items shownRemote Control Batteries Precaution on battery useObserve the following precaution Helpful HintConnections Cable fixing bandsVideo signal connection AV Input Terminals connectionConnections Video 4 pin socketBNC-RCA Component/RGB Input connection Component signals Y, PB, PR connectionRGB signal R, G, B, HD, VD connection Signal Names for D-sub 15P Connector How to connect the PC Input TerminalsInstalling the ferrite core How to connect the Serial Terminals CommandCommunication parameters Basic format for control dataBasic Controls Power On/Off and input signal selection Power On/OffConnecting the plug to the Wall Outlet AC cord connectionSelecting the On-Screen Menu Language Select the input signalPower On/Off and input signal selection On-Screen Menu Display from Remote Control To Picture adjust menu Press to select each item SeeOn-Screen Menu Display from Remote Control ScreenAspect Controls Aspect Controls ZoomJust PanasonicAdjusting Picture Pos./Size Adjusting screenAdjusting Picture Pos./Size Size Clock Phase RGB/PC in ModeHelpful Hint N / Normalise Normalisation PosSound Adjustment MuteBass TrebleSurround Controls OffPicture Adjustments NormalDynamic CinemaAdvanced Settings Picture AdjustmentsSetup for Multi Display How to Setup Multi DisplaySetup for Multi Display Set up Timer Present Time SetTimer Set Setup TimerMode selection Screensaver For preventing after-imagesReversal / Scroll selection To stop the Screensaver under On, press the buttonSetup of Screensaver Time Side Panel Adjustment3D Y/C Filter For Ntsc video images Setup for Input SignalsComponent/RGB-in Select If the picture image becomes unstable Setup for Input SignalsColour system / Panasonic Auto Sync Pull-in rangeClamp position Freq kHz/V-Freq HzTroubleshooting Plasma Display panel Symptoms CheckSpecifications Specifications Customer’ Record