How to connect the Serial Terminals, Command

Connections

How to connect the SERIAL Terminals

The SERIAL terminal is used when the Plasma Display is controlled by a computer.

COMPUTER

SERIAL

Ferrite core	RS-232C
(supplied)	straight cable
D-sub 9p	Less than
	7" 7/8 (20 cm)

Notes:

(1)Use the RS-232C cable to connect the computer to the Plasma Display.

(2)The computers shown is for example purposes only.

(3)Additional equipment and cables shown are not supplied with this set.

6 7 8 9

1 2 3 4 5

Pin layout for RS-232C

The SERIAL terminal conforms to the RS-232C interface specification, so that the Plasma Display can be controlled by a computer which is connected to this terminal.

The computer will require software which allows the sending and receiving of control data which satisfies the conditions given below. Use a computer application such as a programming language to software. Refer to the documentation for the computer application for details.

Communication parameters

Signal level	RS-232C compliant

Synchronization method	Asynchronous

Baud rate	9600 bps

Parity	None

Character length	8 bits

Stop bit	1 bit

Flow control	-

	RS-232C Conversion cable
D-sub 9-pin female		Details
2		R X D
3		T X D
5		GND
4	6	Non use
7		Shorted
8		Shorted
8
1 •	9	NC

Basic format for control data

The transmission of control data from the computer starts with a STX signal, followed by the command, the parameters, and lastly an ETX signal in that order. If there are no parameters, then the parameter signal does not need to be sent.

STX C1 C2 C3 : P1 P2 P3 P4 P5 ETX

		Colon	Parameter(s)	End
		Colon	Parameter(s)	End
Start	3-character		(1 - 5 bytes)	(03h)
Start	3-character		(1 - 5 bytes)	(03h)
(02h)	command (3bytes)

Notes:

(1)If multiple commands are transmitted, be sure to wait for the response for the first command to come from this unit before sending the next command.

(2)If an incorrect command is sent by mistake, this unit will send an “ER401” command back to the computer.

Command

Command	Parameter	Control details
PON	None	Power ON
POF	None	Power OFF
AVL	**	Volume 00 - 63
	**	Audio mute OFF
AMT	0	Audio mute OFF
AMT	1	Audio mute ON
	1	Audio mute ON
IIS	None	Input select (toggle)
	VID	AV Mode
	YP1	Component / RGB mode (processed as a
		Y/PB/PR or RGB signals as set by this unit)
	RG1	PC Mode
DAM	None	Screen mode select (toggle)
	NORM	4 : 3
	ZOOM	Zoom
	FULL	16 : 9
	JUST	Just
	SELF	Panasonic Auto

With the power off, this display responds to PON command only.