Panasonic TH-42PZ80U Select a scanning mode p, Select Edit, Select the item to be edited

Automatically searches and adds available channels to the memory.

Select “ANT in”

Select Cable or Antenna (p. 15)

Select “Auto”

Program channel		next
ANT in	Cable

Select a scanning mode (p. 15)

Auto program	ok
All channels
Analog only	select
Digital only

Auto

Manual

select

Settings are made automatically

Signal meter

After the scanning is completed, select “Apply”. (see below ).

All previously saved channels are erased.

Use this procedure when changing the channel setup or changing the channel display.

Also, use this to add or skip channels from the channel list manually.

You can select a channel tuning mode (Digital only/ Analog only) in “Surf mode”(p. 25)

Select “Edit”

Manual program

EditApply Cancel

Cannnel Caption		Favorite	Add	select
2	...	...	Yes
3	...	...	Yes	next
4	...	...	Yes
5	...	...	Yes

Select the item to be edited

Manual program				select the item to edit
Edit	Apply	Cancel		(Caption/Favorite/
Cannnel Caption		Favorite	Add	Add)
2	...	...	Yes
3	...	...	Yes	next
4	...	...	Yes

5 ...			...	Yes
6 ...			Favorite		• Caption:
			...	Yes
8	Caption...		...	AddYes
7 ...			...	Yes
9 ...			...	Yes	•	Changes the station identifier
Select	OK					Favorite:
	RETURN	R Prev. page G Next page B			Y	Registers channel to Favorite
					•	List
						Add:
			Proceed to			Adds or skips channels
			next page
Go back to previous page

Edit

Caption

Caption select			select
Caption	---		change
Caption detail			set/next
Apply	Cancel
Caption			Caption detail
Select the station identifier			Rename (maximum 7 characters available)
Favorite			select
Set favorite		1/3
1 26-1	- - -
2			next

Set favorite Select the number

Add

Press OK to select “Yes (add)” or “No (skip)”

Move cursor to channel number

Manual program				select
Edit		Apply	Cancel
Cannnel Caption		Favorite Add		Press OK to tune
2	...	...	Yes
3	...	...	Yes	to the channel.
Select “Apply”
program				select “Apply”
	Apply	Cancel
Caption		Favorite	Add
.		...	Yes	ok

Editing and Setting Channels

Advanced

To cancel the Edit

Manual program					Changes will be lost. Continue?		ok
Edit	Apply	Cancel
2	...	...	Yes	select	Yes	No
							(returns to “Program
Cannnel Caption		Favorite	Add
3	...	...	Yes	next			channel”)
4	...	...	Yes				select “Yes”
5	...	...	Yes

Check the signal strength if interference is found or freezing occurs on a digital image.

Signal meter

If the signal is weak, check the antenna.

Channel 1-1 or

change channel

If no problem is found, consult your local dealer.

Signal strength
	Current	30%	Signal intensity
	Peak level	45%

ok Note

Not available if “Cable” is selected in “ANT in” (see above).

Available only for digital antenna channels.

If “Lock” (p. 30) is activated and “Program channel” is selected, “Enter password.” will be displayed. 33