Selecting the input signal
Press to select the input signal to be played back from the equipment which has been connected to the Plasma Display.
Input signals will change as follows:
PC VIDEO 
COMPONENT* HDMI
DVI
VIDEO: Video input terminal in AV IN (VIDEO).
COMPONENT*: Component or RGB input terminal in COMPONENT/RGB IN.
HDMI: HDMI input terminal in AV IN (HDMI).
DVI: DVI input terminal in
PC: PC input terminal in PC IN.
*“COMPONENT” may be displayed as “RGB” depending on the setting of
When an optional Terminal Board is installed:
PC SLOT INPUT VIDEO COMPONENT HDMI DVI
SLOT INPUT: Input terminal in Terminal Board
Note:
When a Terminal Board incompatible with the Plasma Display is installed,
When a Terminal Board with dual input terminals is installed:
PC
SLOT INPUT A SLOT INPUT B VIDEO COMPONENT HDMI
SLOT INPUT A, SLOT INPUT B: Dual input terminal in Terminal Board.
Notes:
•Selecting is also possible by pressing the INPUT button on the unit.
•Outputs the sound as set in “Audio input select” in the Options menu.
•Select to match the signals from the source connected to the component/RGB input terminals.
•In 2 screen display, the same input mode cannot be selected for the main picture and sub picture.
•Image retention (image lag) may occur on the plasma display panel when a still picture is kept on the panel for an extended period. The function that darkens the screen slightly is activated to prevent image retention, but this function is not the perfect solution to image retention.
INPUT MENU 
+/ 
ENTER/ 
DVI
15