Panasonic TH-50PF20U Using Network Function, Example of Network Connection, Command Control

Page 20

Using Network Function

This unit has a network function to control the network connected display with your computer.

Note:

To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT” to “LAN”.

When “LAN” is set, the slot power is turned on, and power indicator is lit orange under the condition of power off with remote control (stand-by state), regardless of the “Slot power” setting.

Example of Network Connection

COMPUTER

Display (main unit, rear)

 

Less

 

than

 

3.9 inch

 

(10 cm)

LAN cable

 

(not supplied)

Ferrite core

 

(supplied)

 

Installing the Ferrite core

 

Ferrite core

Less

Open

 

(supplied)

than

 

 

3.9 inch (10 cm)

 

 

 

Pull back the tabs

Wind the cable

Press the cable

 

(in two places)

twice

through and close

Hub or broadband router

Notes:

Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.

To connect a device using 100BASE-TX, use “category 5” LAN cable.

Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge. Do not touch the LAN terminal or a metal part of the LAN cable.

For instructions on how to connect, consult your network administrator.

Command Control

Network function of the unit can control the unit in the same way as serial control from a network.

Supported commands

Commands used in the serial control are supported. (see page 12)

Note:

Consult your local Panasonic dealer for detail instructions on command usage.

20

Image 20
Contents Contents Risk of Electric Shock Do not Open Important Safety Instructions FCC Statement Trademark CreditsSafety Precautions When using the Plasma DisplayMaintenance Safety PrecautionsSetup AC Power Supply CordRemote Control Batteries AccessoriesAccessories Supplied AC cord connection and fixing, cable fixing ConnectionsSpeaker connection Connections Video equipment connectionVideo and Component / RGB in connection DVI-D Input Connector Pin No Signal Name Hdmi connectionDVI-D in connection Pin LayoutsSignal Names for Mini D-sub 15P Connector PC Input Terminals connectionSignal names for D-sub 9P connector CommandSerial Terminals connection Communication parametersPower on / OFF OSD Language Present Time Setup Display Orientation Power on / OFFWhen first switching on the unit Selecting the input signal PC Video COMPONENT* Hdmi DVIPC Slot Input Video Component Hdmi DVI PC Slot Input a Slot Input B Video Component HdmiRemote control sensor Volume Adjustment Main Power On / Off Switch Power IndicatorInput button Input signal selection see Basic ControlsBasic Controls Remote Control Unit Display the menu screen On-Screen Menu DisplaysSelect the item SetOn-Screen Menu Displays OverviewUsing Network Function Command ControlInstalling the Ferrite core Supported commandsPower Consumption SpecificationsPanasonic Professional Flat Panel Display Limited Warranty For the U.S.A and Puerto RicoLimited Warranty Statement For CanadaPage Software Information for This Product Customer’s RecordPanasonic Professional Display Company Executive Office