Precautions with regard to safety
Do not place your skin into the light beam while the projector is being used.
Strong light is emitted from the projector’s lens. If you place directly into this light, it can hurt or damage your skin.
Do not allow the + and - terminals of the batteries to come into contact with metallic objects such as necklaces or hairpins.
Failure to observe this may cause the batteries to leak, overheat, explode or catch fire.
Store the batteries in a plastic bag and keep them away from metallic objects.
Use manganese batteries or alkaline batteries with the remote control.
Do not touch the leaked liquid from the batteries. If you touch the leaked liquid, it may hurt your skin. Immediately wash away the liquid with water and seek medical advice.
If you get the leaked liquid in your eye, it may cause blindness or damage. Never rub your eye, and immediately wash away the liquid with water and seek medical advice.
Damaged of insulation may cause leak of battery.
Do not place your hands or other objects close to the air outlet port.
Heated air comes out of the air outlet port. Do not place your hands or face, or objects which cannot withstand heat close to this port [allow at least
50 cm (20") of space], otherwise burns or damage could result.
Do not look into the lens while the projector is being used.
Strong light is emitted from the projector’s lens. If you look directly into this light, it can hurt and damage your eyes.
Be especially careful not to let young children look into the lens. In addition, turn off the power and disconnect the mains plug when you are away from the projector.
Replacement of the lamp is recommended to be carried out by a qualified technician.
The lamp has high internal pressure. If improperly handled, explosion might result.
The lamp can easily become damaged if struck against hard objects or dropped, and injury or malfunctions may result.
When replacing the lamp, allow it to cool for at least one hour before handling it.
The lamp cover gets very hot, and touching it can cause burns.
Before replacing the lamp, be sure to disconnect the mains plug from the mains socket.
Electric shocks or explosions can result if this is not done.
Do not allow infants or pets to touch the remote control unit.
Keep the remote control unit out of the reach of infants and pets after using it.
Important Information
CAUTIONS
Do not cover the air inlet port or the air outlet port. Doing so may cause the projector to overheat, which can cause fire or damage to the projector.
Do not place the projector in narrow, badly ventilated places such as closets or bookshelves.
Do not place the projector on cloth or papers, as these materials could be drawn into the air inlet port.
Do not set up the projector in humid or dusty places or in places where the projector may come into contact with oily smoke or steam.
Using the projector under such conditions may result in fire, electric shocks or plastic deterioration. The plastic deterioration may cause the falling down of the projector which is mounted in the ceiling.
Do not set up the projector in a high temperature environment, such as near a heater or in direct sunlight.
Failure to observe this may result in fire, malfunction or plastic deterioration.
Do not set up the projector outdoors.
The projector is designed for indoor use only.
When disconnecting the mains lead, hold the plug, not the lead.
If the mains lead itself is pulled, the lead will become damaged, and fire,
Always disconnect all cables before moving the projector.
Moving the projector with cables still attached can damage the cables, which could cause fire or electric shocks to occur.
Do not place any heavy objects on top of the projector.
Failure to observe this may cause the projector to become unbalanced and fall, which could result in damage or injury.
Do not
Failure to observe this may cause the batteries to overheat, leak, explode or catch fire, and burns or other injury may result.