First Time Setup, Language, Auto program

First Time Setup

For your convenience, First Time Setup menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures displayed on-screen for setting up the features.

Language

The language of the on-screen display is set to English as the factory setting. You can select English, Spanish or French as the on-screen display language.

Procedure

1.Press ▲▼ to select “Language”.

2.Press OK to display the Language menu.

First time setup

Language

Auto program

Picture

3.Press ◄► to select “English,” “Español” or “Français”.

4.Press RETURN to go to previous screen.

Language

Language English

Auto program

You can scan All (Analog and Digital) channels. If needed, follow the menus and procedures displayed on-screen for setting up the features. You can also make the settings in Setup menu.

Procedure

1.Press ▲▼ to select “Auto program”.

2.Press OK to display the Program channel menu.

First time setup

Language

Auto program

Picture

3.Press ▲▼ to select “ANT in”.

4.Press ◄► to select “Cable” or “Antenna”.

Program channel

ANT in

Cable

Auto

5.Press ▲▼ to select “Auto”.

6.Press OK to display the Auto program menu.

Program channel

ANT in	Cable
Auto

7.Press ▲▼ to select “All channels”, “Analog only”, or “Digital only”.

8.Press OK to start scan.

• Channels available for reception will be set automatically.

Auto program

All channels

Analog only

Digital only

Auto program

Scanning digital channel

Progress

Quit40%

9.After Auto program is complete, the unit will return to Manual program mode. To place the channels that were located by auto scan in memory, move the cursor to “Apply” and press OK. (p. 27-28)

If OK is not pressed after selecting APPLY, the channels will not be memorized.

10.Press ▲▼ to select “Picture”.

11.Press OK to display the Picture menu. (p. 35)

First time setup

Language

Auto program

Picture

Notes

•After “Auto program” is completed the unit tunes to the first channel found during “Auto program”.

•If setup is incomplete, check connection of Antenna/Cable to the RF IN Terminal, then try “Auto program” again. (p. 26-27)

•“Auto program” must be done when you select the input signal for the first time or whenever you change the antenna configuration.

•Depending on conditions, “Auto program” may take a while.

Basic Operation