Panasonic TX-47P950A operating instructions Aspect Controls, Mode Picture Explanation

Aspect Controls

	MULTI PIP
	SURROUND ASPECT
R-TUNE	N

OK

MENUTV/AV

TV/TEXT F.P. INDEX HOLD

CH SEARCH STILL

ASPECT

Press to select the different Aspect options.

AUTO	16:9	14:9	JUST
ZOOM3	ZOOM2	ZOOM1	4:3

Notes:

•Simply press ASPECT ASPECT to display mode information in the top left of the screen. Whilst the on screen selector keys are displayed, use the Red or Green buttons to move in either direction through the eight aspect options.

•16:9 picture has been used to illustrate all of the aspect modes described in this section.

The on screen selector keys (corresponding to the four coloured buttons on the remote control) appear for some Aspect functions and disappear after a few seconds. If you would like to select an operation when the keys are not shown, press ASPECTASPECT once

more and the keys will reappear.

Helpful Hint ( N Normalization)

By pressing the Normal “N” Button on the Remote Control while the Aspect menu is displayed, the selected menu will be changed to the Normal Mode.

Normalization will not occur if the menu is not displayed when the “N” Button is pressed.

The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.

Mode			Picture		Explanation
					The AUTO position can be set to 16 : 9. When a
AUTO					wide screen signal is detected at the Video
					terminal the TV will select the 16:9 aspect ratio.
				4:3 Signal
	16:9 Signal
					The 16:9 option will display the picture at its
					maximum size. Signals in the 4:3 format will be
16 : 9					stretched to fit the picture.
	16:9 Signal			4:3 Signal
					The 14:9 option will display a 4:3 signal in
14 : 9					simulated wide screen. The picture is slightly
					stretched. It is also slightly cropped top and
					bottom.
					JUST gives you a best fit option when showing
JUST					4:3 on wide screen. The centre of the picture is
					not affected but there is some stretching at the
					edges.
					This option will display a standard 4:3 picture
4 : 3					without any stretching or compression. There
					will be vertical gray lines down either side of the
					picture.
		ZOOM1			This option allows you to magnify the picture.
ZOOM1

	ZOOM2	The picture becomes larger and larger when
ZOOM2,		you change the mode ZOOM2 and ZOOM3.
ZOOM3

Notes:

•ASPECT operations cannot be made during progressive (Y, PB, PR) or 1080i signal input.

28