Panasonic TX-47P500H, TX-47P500X Connecting the Plug to the Wall Outlet, How to Turn the Power On

Before Operating This Set

Connecting the Plug to the Wall Outlet

Note:

Main plug types vary between countries. The main plug shown at left may therefore not be the type fitted to your set.

How to Turn the Power On

Power Indicator

Power Switch

Power OFF	Power Indicator
	No light: Power OFF condition

Note: Even when the Power Switch is "OFF", the TV set

will still consume a small amount of power.

Power ON	Push the Power switch on Television to turn the set on.
		Power Indicator
		No light: Normal viewing condition
		Red : Stand by

Notes:

•When in the Stand-by condition (Refer to page 15), it is also possible to turn the TV set on by pressing any of the “Direct Programme Number Selection buttons” (0~9) or “Programme Number Up or Down buttons” on the TV set or on the Remote Control.

•If the Wall Outlet is switched OFF or the Main Plug is unplugged, when the TV set is again turned ON (by either connecting the Main Plug to the Wall Outlet or switching the Wall Outlet ON), it will have returned to the original state.

Battery Installation

1 Open the cover.	2 Batteries: Use two “R6 (AA)” size 3 Replace the cover.
Apply slight downward pressure	batteries.
while pulling towards the bottom.	Insert the batteries ensuring the correct
	polarities.
	This is identifiable by the “+” and “− ” symbols
	on the batteries and inside the battery
	compartment.
	Two “R6 (AA)” size

Do not use rechargeable (Ni-Cd) batteries.

They are different in shape and performance and may fail to ensure correct operation.

Battery cautions

The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the batteries to burst.

Old Batteries New Batteries

Replace both batteries at the same time.	Don't mix diffrent battery types	Don't Recharge.
	(alkaline with carbon zinc, etc.)

7