Panasonic PT 52DL52 manual Operating peripheral equipment using the remote control, Seconds

Operating peripheral equipment using the remote control

Programming Without A Code (When the code is not known)

This procedure searches all codes and is called the “sequence method.”

					SAP
POWER		T
	ECT
		V/VI
SP				DE
A					O
E					LI
T					G
U					T
M					H
	DVD		AU	X	RCVR
VCR			CBL
	DTV
TV					DBS
	CH
	TI
	C	O
	A	N
VOL			VOL

CH

BBE		RECALL
MENU
EXIT	PAGE	GUIDE

1	2	3
4	5	6
7	8	9
R-TUNE	0	PROG
PIP MIN	PLAY	PIP MAX
REW		FF
PAUSE	STOP	REC
FREEZE	PIP CH	SEARCH
TV/VCR	VCR CH	OPEN/CLOSE

PIP SPLIT MOVE SWAP

1	Confirm that the external component is plugged in and on.
2	Turn the component off.
3				CH			Press POWER and ACTION together, for at least 5
			C			N
				TI
		+	A		O
	POWER					VOL	seconds.
			VOL
				CH			After 5 seconds, all the illuminated mode keys will
							begin to flash.
							Release the POWER and ACTION key.
4		DVD	AUX			RCVR	Press the mode key.
	VCR
		DTV	CBL				The mode key will illuminate steadily, all others will go
	TV					DBS	out.
5							Press to move forward to the next code, or to move
		CH					backward.
		TI
		C	O
			N
		A
		VOL	VOL

CH

6 POWER

Press the Remote Control POWER to test the component. If the procedure was

successful, the component will turn on.

Note:

Repeat the above steps until the component code is found. It may take many attempts before the correct code is found.

7

CH		After the code is found, press ACTION to store the code.
TIO
C	N
A
VOL		VOL

CH

Note:

The step and set mode will start from the current device (not the beginning of the list, except for the first time).

59