Panasonic TC 11LV1 Installation, Precaution on battery use, Requires two AAA batteries

Installation

SUPPLIED ACCESSORIES

Check the accessories before installations.

• Operating Instruction book	• Remote Control Transmitter
(TQBC0357/0358/0359)	(TNQE284)
		EJECT DISPALY
	POWER
		ANGLE	M DVD
			ENU
		ENTER
	TV
	MENU		RETURN
	SKIP	SLOW/SEARCH
	STOP	PAUSE	PLAY
	ASPECT TV/VIDEO MUTE
	SLEEP	CH	VOL
	SURROUND
			CANCEL
	REPEAT MODE	A-B REPEAT PLAY MODE
		R-TUNE

•Battery for the Remote Control Transmitter

(2 ⋅ AAA size)

•

•

Warranty Card	• AC Adaptor & AC Cord
(TQDC18014)	AC Adaptor: (N0JZHK000005)
	AC Cord: (K2CA2EA00005)
Service Center List
(TQBC7055-2)

Remote control battery installation

Requires two AAA batteries.

1.Turn the transmitter face down. Remove top cover by pressing down on marking and sliding cover off in the direction indicated.

2.Install the batteries as shown in the battery compartment. (Polarity + or – must match the markings in the compartment).

3.Replace the cover and slide in reverse until the lock snaps.

Helpful Hint:

For frequent remote control users, replace old batteries with Alkaline batteries for longer life.

Two AAA size

Precaution on battery use

Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.

Observe the following precautions:

1.Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.

2.Do not combine a used battery with a new one.

3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when the remote control acts sporadically or stops operating this unit.

7