LOREX Technology L224 Series Advanced Menu Remote, Device, Protocol, PTZ Camera Connection

4.10 ADVANCED MENU ___REMOTE

Move the cursor to “REMOTE” and press ”ENTER”. The screen will show the following options.

REMOTE

TITLE	DEVICE	ID	PROTOCOL	RATE
01	PTZ	001	P - D	02400
02	CAMERA	002	NORMAL	02400
03	CAMERA	003	NORMAL	02400
04	CAMERA	004	NORMAL	02400

1)TITLE:

Title of each camera.

2)DEVICE:

Select to control a normal camera or a PTZ camera for each channel.

3)ID:

Set the ID number (0 ~ 255) of PTZ camera.

Note: After connecting to a PTZ camera correctly, the default ID of PTZ camera will be shown on the screen.

4)PROTOCOL:

Select NORMAL (our protocol) or PELCO-D protocol.

5)RATE:

Set the baud rate of each channel (2400, 4800, 9600, 19200, 57600). For the connected cameras, such as PTZ and speed dome cameras, etc., please make sure the baud rate setting is the same as the setting here.

PTZ Camera Connection:

1)Connect the PTZ camera with indicated power supply.

2)Connect the PTZ camera video output to the DVR video input port with a coaxial cable and BNC connector.

3)Connect “RS485-A” line (brown color) to RS485-A port on the rear panel of the DVR. Connect “RS485-B” line (orange color) to RS485-B port on the rear panel of the DVR.

Note: For detailed camera ID, protocol and baud rate setup at DVR side, please refer to the description above. For detailed camera ID, protocol and baud rate setup at remote AP software side, please refer to “Device” at page 39 (AP software system configuration). For detailed PTZ control instructions, please refer to “Digital Device Control Panel ~ PTZ” at page 35.

21