Jwin JD TV108 manual 2Disc Handling and Maintenance

Page 43

5-2Disc Handling and Maintenance

Handling Precautions

Hold the disc by the edges so the surface will not be soiled with finger- prints. (A)

Fingerprints, dirt and scratches can cause skipping and distortion.

Do not write on the label side with a ball-point pen or other writing utensils.

Do not use record cleaning sprays, benzine, thinner, static electricity prevention liquids or any other solvent.

Be careful not to drop or bend the disc.

Do not install more than 1 disc on the disc tray.

Do not try to close the disc tray when the disc is not installed properly.

Be sure to store the disc in its exclusive case when not in use.

If the surface is soiled (B)

Wipe gently with a soft, damp (water only) cloth.

When wiping discs, always move the cloth from the center hole toward the outer edge.

(If you wipe the discs using a circular motion, circular scratches are likely to occur, which will cause noise.)

If the disc is brought from a cold to a warm environment, moisture may form on the disc

Wipe the moisture off with a soft, dry, lint-free cloth before using the disc.

Improper disc storage

You can damage discs if you store them in the following places:

Areas exposed to direct sunlight

Humid or dusty areas

Areas directly exposed to a heat outlet or heating appliance

Playable disc format

MPEG4, DVD, DVD+RW, DVD+R, DVD-RW, DVD-R, CD-DA, Mixed CD-DA, JPEG file disc and Kodak Picture Disc.

Disc which cannot be played with this player

CD-ROM

CVD

CD-G

Maintenance

Be sure to turn the unit off and disconnect the AC power cord before maintaining the unit.

Wipe this unit with a dry soft cloth.

If the surfaces are extremely dirty, wipe clean with a cloth which has been dipped in a weak soap-and-water solution and wrung out thoroughly, and then wipe again with a dry cloth.

Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. Do not use compressed air to remove dust.

(A)

(B)

PORTABLE DVD PLAYER USER GUIDE

39

Image 43
Contents Portable DVD Player Page Contents Disc Handling and Maintenance Audio SetupLCD Setting TroubleshootingNever make or change connections with the power switched on FCC and Safety InformationImportant Safety Instruction Power cord protection PrecautionsSelecting the Type of Disc for the Type of TV Connected About This User Guide 1Getting Started Battery Installation for Remote ControlFront View Right Side View Top ViewService life of battery Connect the unit to external equipment and/or to earphones Press Power button on the top panelFor Picture File Playback Only Input from External EquipmentAudio or video cable External equipment by connecting the porYou could input images and sounds from Table DVD player to external equipment withFavorite To Select a Specific ChannelTo Select Preferred Available Channels FreqBasic Playback Pausing PlaybackUsing Volume Function Stopping PlaybackRepeating Sections Between Two Specific Points A-B Repeat Fast Forward and BackwardSkipping a Chapter Ahead or Back Repeat ViewingFor Band 3D Audio Output AdjustmentFor Surround Srnd For EQViewing from Different Angles Using a DVD MenuChanging Subtitle Languages Zooming a Scene During PlaybackProgramming DVD Playback Searching Scenes During PlaybackPress Up / Down Left / Right to highlight an item Playing an Audio CD without a Title Menu 2Audio CD OperationOK or Play Up / Down to highlight a track and then press OK or PlayTo prestop the disc playback, press Stop once Skipping a Track Ahead or BackRepeating Playback Displaying Track InformationPress Left / Right to select a feature Channel Audio Output AdjustmentRepeating Sections Between Two Specific Times A-B Repeat Programming Music Playback Searching Music During PlaybackEnter a preferred Track Number by pressing Number Buttons Playing a Jpeg Picture CD with a Title Menu Slideshow begins in full screen mode3Kodak and Jpeg Picture CDs Operation Playing a Kodak Picture CDDisplaying Picture Information Rotating PicturesZooming Pictures Skipping a Picture Ahead or BackProgram again Changing Slideshow DisplayInitial OSD Setting Major OSD SettingsPress Setup to enter Setup Menu Left Right to 1Language SetupOSD Language Audio LanguageDown to highlight Subtitle Subtitle Language Menu LanguagePress Down to highlight Menu Press Down to highlight Downmix 2Audio SetupDigital Out DownmixPress Down to highlight Night Night ModeHighlight Audio Setup icon Down to highlight a preferred option. Press OKPress Down to highlight Video Output 3Video SetupVideo Output TV AspectPress Down to highlight Brightness BrightnessLetter Box WidePress Down to highlight HUE Contrast HueSaturation TV System Screen Saver Angle Mark 4System SetupDown to highlight a preferred option Press Press Down to highlight Default DefaultPanel Setting Invert Setting +3 Panel +2 Invert +1 Color 0 Bright -1 -2 Color Setting Bright SettingPanel +3 Invert +2 Color +1 Bright Symptom Common Remedy 1Troubleshooting1Troubleshooting 2Disc Handling and Maintenance