Jensen operation manual DVDB01 Preparation, Tools and Supplies, Disconnecting the Battery

DVDB01

PREPARATION

It’s a good idea to read all of the instructions before beginning the installation. We recommend having your JENSEN DVDB01 installed by a reputable installation shop.

Tools and Supplies

You will need these tools and supplies to install your DVDB01:

•Torx type, flat-head and Philips screwdrivers

•Wire cutters and strippers

•Tools to remove existing radio (screwdriver, socket wrench set or other tools)

•Electrical tape

•Crimping tool

•Volt meter/test light

•Crimp connections

•18 gauge wire for power connections

•16 – 18 gauge speaker wire

Disconnecting the Battery

To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation.

NOTE: If the DVDB01 is to be installed in a vehicle equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.

4