7
BLOWER INSTALLATION
Blower (SEE LOCATION AND CLEARANCES)
1.Cut and remove the tie securing the blower switch wires to the heat shield.
2.Connect the white wire coming from below the unit to the terminal on the blower.
3.Connect the black blower wire to the black wire coming from below the unit.
4.Insert the clips on the blower housing into the cutouts in the rear shield. Push down to lock the clips into position.
5.Secure the blower using the screw and lock washer sup- plied.
Note: Ensure that all the wires are tucked into the blower
switch housing.
7
7
9
8
1 4 4
2
3 
5
1 4 4
2
3 
5
Switches
6.Open the switch housing by removing the top screw.
7.Install the thermodisc bracket as shown, using 2 of the screws supplied. Connect the flagged leads to the terminals of the thermodisc.
Remove the knock out from the housing label.
8.Install the variable speed switch (rheostat) into the housing with the wires facing up. Secure the switch to the housing using the pal nut and the knob supplied.
9.Connect the male connector on the switch to the female connector coming from the unit.
10.Tuck all of the wires into the housing and close. Secure using the screw removed in step 6.
7
7
9
8
ACCENT LITE REPLACEMENT
Your Bayfield comes equipped with our “Accent Lite”. If in the event the lamp or lens needs to be replaced, follow these instructions.
Disconnect the two wire leads at the wire nut. Remove the four screws securing the accent lite assembly from the relief door. Disassemble the lite and the lamp now can be accessed
Note: Do not handle the lamp (bulb) with bare fingers, protect with a clean dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp and lens are special “high RAIL temperature” products.
When
WIRE NUT 
SHEILD
COVER PLATE
GASKET
GLASS LENS
GASKET
RELIEF
DOOR RAIL
THE FIREBOX
MUST BE SEALED.
When
“Light Leakage” from above the cast doors may be noticed. The holes in the lamp housing are necessary for ventilation and must not be covered.
