FUNAI V7PFDVD20 owner manual Introduction, Important note is located on the rear of the cabinet

Page 2

INTRODUCTION

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS AP- PLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT.

THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANY- ING THE APPLIANCE.

The important note is located on the rear of the cabinet.

Important Safeguards

1.READ INSTRUCTIONS - All the safety and operating instructions should be read before the appliance is operated.

2.RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for future reference.

3.HEED WARNINGS - All warnings on the appliance and in the oper- ating instructions should be adhered to.

4.FOLLOW INSTRUCTIONS - All operating and use instructions should be followed.

5.CLEANING - Unplug TV from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

EXCEPTION: A product that is meant for uninterrupted service and, that for some specific reason, such as the possibility of the loss of an authorization code for a CATV converter, is not intended to be unplugged by the user for cleaning or any other purpose, may exclude the reference to unplugging the appliance in the cleaning description otherwise required in item 5.

6.ATTACHMENTS - Do not use attachments not recommended by the TV manufacturer as they may cause hazards.

7.WATER AND MOISTURE - Do not use this TV near water, for ex- ample, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, and the like.

8.ACCESSORIES - Do not place this TV on an un- stable cart, stand, tripod, bracket, or table. The TV may fall, causing serious injury to someone, and serious damage to the appliance. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold

with the TV.

Any mounting of the appliance should follow the manufacturer’s instructions and should

use a mounting accessory recommended by the manufacturer. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appli- ance and cart combination to overturn.

AMEUBLES - Cet appareil ne doit être placé que sur un meuble (avec ou sans roulettes) re- commandé par le fabricant. Si vous l’installez

sur un meuble à roulettes, déplacez les deux ensembles avec précaution. Un arrêt brusque, l’utilisation d’une force excessive et des

surfaces irrégulières risquent de déstabiliser l’ ensemble et de le renverser.

9.VENTILATION - Slots and openings in the cabinet and the back or bottom are provided for ventilation and to ensure reliable opera- tion of the TV and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the TV on a bed, sofa, rug, or other similar surface. This TV should never be placed near or over a radiator or heat register. This TV should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to.

10.POWER SOURCES - This TV should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For TVs intended to operate from battery power, or other sources, refer to the operating instructions.

11.GROUNDING OR POLARIZATION - This TV is equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

12.POWER-CORD PROTECTION - Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

13.OUTDOOR ANTENNA GROUNDING - If an outside antenna or cable system is connected to the TV, be sure the antenna or cable system is grounded so as to provide some protection against volt- age surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA No. 70, provides information with respect to proper grounding of the mast and supporting struc- ture, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. (Fig. A)

FIGURE A

EXAMPLE OF ANTENNA GROUNDING AS PER

NATIONAL ELECTRICAL CODE

ANTENNA

LEAD IN WIRE

GROUND

CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

ELEC TRIC

SER VICE

EQUIPMENT

GROUNDING CONDUCTORS (NEC SECTION 810-21)

 

GROUND CLAMPS

NEC - NATIONAL ELECTRICAL CODE

POWER SERVICE GROUNDING

 

ELECTRODE SYSTEM

 

(NEC ART 250, PART H)

14.LIGHTNING - For added protection for this TV receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the TV due to lightning and power-line surges.

15.POWER LINES - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light of power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

16.OVERLOADING - Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

2

EN

Image 2
Contents V7PFDVD20 Introduction Important note is located on the rear of the cabinetRADIO-TV Interference PrecautionsLaser Safety Important Copyright InformationLocation Supplied AccessoriesSymbols Used in this Manual To Avoid the Hazards of Electrical Shock and FireContents IntroductionDTV/TV/CATV Features¨ Accessing from Mode button Remote Control Function Installing the BatteriesControl Panel Rear PanelConnection Basic ConnectionFront of this unit External Device ConnectionDigital audio coaxial cable RCA video cableMain Menu Initial SettingTV Functions Initial Setup Auto Channel Scan When connected to CATV, select Auto Preset CH CatvChannel setting will be saved even if the power fails Language SelectionChannel Selection What is the minor channel?Watching TV To use the Number buttonsBroadcasting Information Switching Each ModeScreen Information Press DisplayLetterbox TV Screen Display Mode5Sleep Timer ZoomChannel Add/Delete Optional SettingPicture Adjustment Bright Contrast Color Tint SharpnessOFF CAPTION1 CAPTION2 TEXT1 TEXT2 Closed CaptionPress SET-UPto display the main menu CAPTION1 and TEXT1Use Cursor K/ L to select DTVCC, then press DTV Closed CaptionDtvcc EnterChip TV Rating To Set the Sub RatingsMpaa Rating Change PasswordEnter password again in Confirm Password space Use Cursor K / L to selectUnplayable Media Operating DVDDVD Functions Playable Media Any other discs without compatibility indicationsPress OPEN/CLOSE a Press POWERy to turn on the unitPlayback Fast Forward / Fast Reverse During playback, press Mode repeatedly until appears5Step-by-step Playback Slow Forward / Slow ReverseTrack Search Search FunctionsChapter / Title Search Direct Search Time SearchRepeat Playback Repeat A-B PlaybackProgrammed Playback Stop mode, press Mode repeatedly until Random menu appearsRandom Playback Press Play B to start random playbackOn-screen Display Total tracksENG Special SettingsSubtitle Language SPASetting will be kept even if the unit is turned off Black Level SettingStereo Sound Mode Virtual SurroundMarker Setup Use Cursor K/L repeatedly until marker search menu appearsSubtitle *1, *2 DVD SettingDVD Language Setting Disc Menu *1Still Mode Display SettingEnter TV Mode Use Cursor K/L to select AUDIO, then press DVD Audio SettingDRC dynamic range control Default on Select DRC Down SamplingParental Setting Use Cursor K/L to select PARENTAL, then pressYou can change the other functions Angle Icon Default onOthers Use Cursor K/L to select OTHERS, then pressUse Cursor K/L to select INITIALIZE, then press Reset to the Default Setting5Language Code List Use Cursor K/L to select YES, then press EnterTroubleshooting Troubleshooting GuideEntered channel number Check the batteries of the remote controlRefer to IR Signal Check on Changes automaticallyGlossary MaintenanceInformation AtscOther Specifications General SpecificationsElectrical Specification Cable Channel DesignationsInformation 43 EN Transferability and Renewals Limitations of Implied WarrantyLimit of Liability Subrogation