Haier LED19, LED40T3 USB Mode, To USE the USB Device, When connecting/removing the USB device

Using the features

VTime

While in normal TV mode only, pressing the button will display the teletext time in the top right hand corner for a few seconds.

BSupported equipment:

Support the equipment that supports Mass Storage Protocol and whose file system is FAT32, such

as some USB disks, mobile harddisks, and MP3 player. If USB equipment could not be identified due to unsupported file system, please format the equipment to the above-mentioned file system.

V Fast text coloured buttons

Fast text automatically displays the four most commonly used pages that the broadcaster thinks that you may want to choose next. Press the same coloured button on the remote control as the coloured link at the bottom of the teletext page to go directly to that page.

VSubcode

Pressing the button by entering its 4-digit number to enter a secondary page.

USB MODE

Note

OThe diagrams in the following section are schematic and only for your reference. Please see the actual product if necessary.

TO USE THE USB DEVICE

ASupported file formats:

t
Photo: *.jpg;

t
Music: *.mp3 files;

t
Movie: *.avi files;

t
TEXT: *.txt

Note

ODue to the particularity of file cording, some files may be unable to read.

CTo achieve smooth playing, ensure the following:

t
The file code rate should be lower than 300KB/S; t
Due to the limitation of USB signal transmission

distance, it is recommended not to use USB patch cord, in case of using the cord, make sure that its length is not over 1m;

t
Use high-speed USB equipment in conformity with USB2.0 full speed Interface Standard; If USB equipment in conformity with USB1.1 full speed Interface Standard is used, the playing may be unsmooth.

When connecting/removing the USB device

APress “SOURCE” on the remote control unit to select USB option.

BInsert USB equipment into corresponding USB interface 2s after starting the system.

C After entering the system menu, press “ / “ on the remote control unit to select the require USB files, press “OK” button to confirm the selection and enter the file list relative to the selection.

D Press“ / “ on the remote control unit to select the required file, press“OK” button to enter the selected file.

ETo exit the streaming media playing system and watch a TV program, you must press “BACK” button to return to the streaming media main menu at first (to protect equipment), and then press “SOURCE” to select “TV” to return to the TV mode.

Note

QUnder source of USB, when press button MENU, screen goes black, except when images or movies are being played.

QWhile playing the USB, press “BACK” button repeatly, the screen picture will return to USB main interface, and only at this time you can switch corresponding signal sources by pressing “SOURCE” again.

EN-27 Digital LCD Television Instruction Manual