Haier LED19, LED40T3, LED22T3 instruction manual Troubleshooting, Playing AN Audio CD

Using the features

V PLAYING AN AUDIO CD

AInsert a CD in the same way as you would a DVD, with the label facing away from you.

BThe CD will load and a menu of the disc’s contents will appear on screen.

C Use the and buttons to highlight the track you wish to play and press PLAY/PAUSE, or just press PLAY/PAUSE to listen to the whole CD from the beginning.

You can stop, pause, fast forward or fast rewind a CD in the same way as a DVD. You can also use the REPEAT button to repeat a track, folder album or the contents of the whole disc. Press repeatedly to select what you would like to repeat. You can also use the A-B function to repeat a certain section of a track or CD.

Reference Sections

TROUBLESHOOTING

„To assist in location of possible faults use the help guide below:

	Verify if the television is
No picture, no	properly plugged in.
	Verify if the television has a
sound
	proper supplied power source.
	Verify if electricity is available.
	Verify if correct signals are
	input.
Blank screen	Operate the remote to change
	signal input to correct input.
	Restart the television if power
	supply is interrupted.
	Press MUTE button and verify if
	Mute mode is set.
No sound	Switch to other channel and
	verify if the same problem
	happens.
	Press VOL+ button to see if the
	problem can be solved.
Poor sound	Verify if sound system is correct.
	Refer to user‘s manual for
	adjustment.

No picture in	Verify if correct channel is
	selected.
some channel
	Adjust the antenna.
No color for	Verify if the same problem exists
	in other channels.
some channel	Check out of picture and sound
program	systems.
(black and	Refer to relative instructions
white)	in the Manual for color
	adjustment.
	Verify if the antenna is correctly
Spots with	connected.
	Verify if the antenna is in good
some or all
	condition.
pictures
	Make fine adjustment of
	channel.
	Disconnect the television from
	power supply and 10 seconds
Television out	later, connect the television
	to the power supply. If the
of control
	problem still exists, contact
	authorized after-sales service
	for technical assistance.

Note

OIf the fault can not be repaired using the above guide consult with your local authorized service centre.

OThe TV set must only be repaired by a qualified registered service person. Never attempt to remove the back cover as the TV set has dangerous voltages in side that may cause a fatally or fire.

EN-33 Digital LCD Television Instruction Manual