Time Shift, Recording | Haier LED19, LED40T3, LED22T3 manual

Using the features

Note

OThe system will format the whole device and if your device size is bigger than 1GB, you can set the size which is used for time shift.

FFormat may take several minutes and the time is

depending on the memory size. Press button to select the Time Shift Disk Size. The max device size for Time Shift is 8GB. Then, press OK button to save.

IMPORTANT

tUSB device should be format as FAT32 format by your PC before insert to the USB connector.

TIME SHIFT

Time Shift function is only available in DTV mode. Press PLAY/PAUSE to pause the program, and press PLAY/ PAUSE again, the time shift program will be played. If you want to stop time shift function, press the STOP button.

You can stop the time shift program being played by pressing the STOP button.

Note

OIf you select all the size format for time shift, you can not do any recording.

GWaiting for the system checking. And you can see the speed data after the success checking.

Note

OOnly have to format when you use the device for record for the first time.

OThe minimum device size for record is 1GB. Provide device formatting function is up to 2TB. The max Multi-Partition is 16 partitions and one is active at a time.

OBit rate:

tDevice bit-rate>4.5MB/s REC is safe at HD stream

tDevice bit-rate>1.5MB/s REC is safe at SD stream

tDevice bit-rate<600KB/s REC is bad for REC

OThe system can not work normally if the USB device have the listing problem below:

t The device has bug.

t The device has error block.

t The device reports the unfaithful size.

RECORDING

APress D.MENU button to record the program being played, and press D.MENU or EXIT button to make the recording interface minimum.

BPress STOP button to stop the program recording being played.

CFor Playback the recorded program. Press INDEX button to open the recorded list.

Digital LCD Television Instruction Manual EN-30