Audiovox VOD916/PROV916/PROV916 S/PROV916 P, Optional, Auxillary, video display, Tv Antenna

VOD916/PROV916/PROV916 S/PROV916 P

			Hard Wired FM Modulator Output
			12 VDC Power and Ground
		Satalite
TO	Am/Fm	Radio	FM
FACTORY	Antenna			14Pin FMM Cable
RADIO			Modulator
	Dash Radio			Item #8
			Second IR
			Input

CHOKE

Power Harness

Item #3

To Secondary AV Monitor

	INPUT	RCA-Female
12 VDC Power and Ground
	VIDEO			TO
			LINE	OPTIONAL
Auxillary			OUT	ADDITIONAL
		Patch Cord		MONITOR
video display			VIDEO
		RCA Male to Male
			(Yellow)

Battery 12V

Line Out-L (White)

Line Out-R (Red)

Line Out-V (Yellow)

TV

ANTENNA

Optional Remote Headphone Stations

Green (Right+)

Black (Ground)

Gray (Left+)

Stereo Headphone Jack

Stereo Headphone Jack

Power Harness

Item #3

	Accessory
Dome Light	Harness - Optional
	(P/N:8010730)
Power Source
	Red RCA (Audio Right)
	White RCA (Audio Left)
	Yellow RCA (Video)

OPTIONAL

PowerConnector

4 Pin

Clean the IR Receiver Window on the front of the VCP. Remove Adhesive Backing and Apply IR LED to IR

"Y" Adapter for use with Non-Stereo Installations

Item# 5

Figure A

1)Make the connections to the vehicle for the 12 pin wiring harness and battery wire.

2)Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

3)Pull the wire tie loop tight and cut off the excess.

4)Connect the 12 pin harness to the mating connector on the Video Monitor.

5)Connect the wired headphone to the remote headphone jacks to the video monitor if those options are being included.

6)Connect the 14 Pin wire to the FM modulator.

7)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.

8)Verify all functions of the System before final mounting of the finished assembly.

9)Mount and connect the Television antenna.

Note: A VCP or other A/V Component can be connected to the video monitor system using a second

source component harness (purchased separately, part number: 8010730). This harness would plug into the Mini-Din connector on the main PCB as in steps 2 and 3 above.

A/V Source Definitions:

1= VCP or VCP with TV Tuner (Mini-Din on main PCB) 2= AUX-IN (VCP, Game or future DVD etc...)

3= Built-in DVD

-6-